hi, I'm looking for some advice on the performance of my 2.25 diesel (3 bearing). I know they don't have the best reputation for power and I haven't driven any other series Land Rovers with the same diesel. it starts and runs ok without too much smoke, however seems to have a hard time getting into 4th and has to be really thrashed. is this normal? perhaps just a consequence of the large difference between 3rd and 4th? im just curious to figure out the health of all the timing components and injector pump without tearing it all to bits. thanks.
2.25 diesel performance
- Thread starter woo0003
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Dorset_dumpling
Well-Known Member
- Posts
- 914
- Location
- Poole, UK
Just a quick query before you start worrying about the engine, what size tyres are you running? The diesel is ideally suited to 6.00/16 tyres Many people fit 7.50/16s which can leave the diesel feeling slightly over-geared, trading off even worse acceleration for slightly reduced cruising rpm. The realistic comfortable cruising speed of the diesel is about 45-50 mph and anything other than a gentle hill will require 3rd gear.
steve2286w
Well-Known Member
- Posts
- 4,522
- Location
- monkeyangerland
you could compare with these
www.landyzone.co.uk
Slow diesel road test
Flat road no wind pulling away in 2nd, pity i cant put the vid on here changed from 2nd to 3rd at 25mph in about 10secs got to 40mph in 3rd in about 20 secs with a max speed in 3rd of 45mph In 4th i got 55mph in 39 secs and back to zero in about 46secs it must be running well today it went up a...
www.landyzone.co.uk
- Posts
- 33,599
- Location
- North Shropshire
I would say.. define 'thrashed'?
There is no 'performance' page on the user handbook, only 62bhp diesel/77bhp petrol
There is no 'performance' page on the user handbook, only 62bhp diesel/77bhp petrol
Last edited:
tottot
Well-Known Member
- Posts
- 8,027
- Location
- west wales coast
And some of those GG's are sure to have escaped over the years.
- Posts
- 33,599
- Location
- North Shropshire
Last seen in lunnen
Bobsticle
De Villes Advocaat
- Posts
- 27,632
- Location
- Manchester
As said it’s a good idea to check road wheel size and also count the teeth on your difs. Most wheels are changed for aesthetics rather than performance and sometimes the gearing of the differentials changed in an attempt to improve top speed. Your far better knowing what the transmission train is doing before looking at the engine.
