Freelander 1 1.8 bottom rad hose

tlo · Jul 6, 2018

Ok me thinks I have sorted it ,I have opened both bleed valves and only water is coming out .In my haste to sort it I reilised I had not added the antifreeze

This is me being lazy

but as far as I am aware I will need 3L of antifreeze is there away to drain off the 3L instead of the whole thing ? I really don't want to go down that route again

Alibro · Jul 6, 2018

I guess you could pull the return pipe off the header tank and drain off 3 litres while topping it up with antifreeze .

Nodge68 · Jul 7, 2018

I'd allow the water to flow out the lower bleed screw while topping the header up with concentrated coolant. Close the bleed screw when the water changes colour to the coolant. Then over the next few weeks, top up with concentrated coolant, as the last of the air purges out. If you start with a measured quantity of concentrated coolant, you'll know you have the correct ratio, when you've used the measured amount.

tlo · Jul 7, 2018

Thank you lads one thing I have noticed is every now and then there is a leak from the back of the engine I have had a look and can not see were it is coming from . I know the manifold o rings have been changed ,then sometimes nothing it seems when it starts to pressurize it stops . Then again it is a k series engine next job antifreeze

Alibro · Jul 7, 2018

tlo said:
Thank you lads one thing I have noticed is every now and then there is a leak from the back of the engine I have had a look and can not see were it is coming from . I know the manifold o rings have been changed ,then sometimes nothing it seems when it starts to pressurize it stops . Then again it is a k series engine next job antifreeze

It could be the inlet manifold, it's not unknown for the gasket to get nipped when it's refitted. If you're unlucky tho it could be the head gasket.

Freelander 1 1.8 bottom rad hose

tlo

Active Member

Alibro

Well-Known Member

Nodge68

Well-Known Member

tlo

Active Member

Alibro

Well-Known Member

Similar threads