Search results

Hi, get yourself a good quality clear mastic run a bead of mastic on the top of the trim, 5 min job done mine 2years ago still no leaks .

hi,i may be a bit late with this reply ,I used lynx diesels to refurb my original injectors excellent service and cheaper than what you paid on ebay,when having telephone conversation with alan darby who runs lynx diesels he asked for code number on the injector as there are different ones...

Hi td4van, checked the heater issue your right , one to cross off the list, booked into a independent next week he says this issue should show up on t4 diagnostic plenty off checks to do before he condemns the ecu, hope to keep site posted.

hi digby, auto elec said it was draining 0.8 amp,

hi nodge68, iv had the vehicle for 2yrs I always park on my drive same location ,the alarm symptoms is happening on my drive, at work and round town were I park up. the heater fan is set to1 when engine revs increase from 750 to 900,thanks.

hi datatek, thanks for quick reply, been outside and checked inside footwells both sides dry no signs of damp, battery is 6mths old and was checked by the auto elec. thanks again.

hi all, having trouble with battery draining over 2-3 days, took the vehicle to the local auto elecs he did the usual checks fuses relays and still showing drain, he thinks the ecu is not shutting down causing the drain. also its a coincidence that intermittently when cancelling the alarm...

Hi dog-man found it by chance, engine ticking over I moved the harness and it caused erratic running at tick over , having taken harness of the vehicle I did a test on each wire and one was breaking down on movement , got anew harness from indie for £35ish

I had same problem between 1500 _2000 rpm turned out to be fuel rail pressure sensor wiring harness , took me 20 minutes to fit , all ok after

Hi folks just asking if anyone can give me a contact for a gear selection rod the smallest of the two that connects to the gear box, new if poss, mine as dropped off at the ball and socket nearest the gear box currently held on with a cable tie to get me home

Any chance of the link hippo, thanks

Hi, just checked mine still in the box after refurbishment by bell engineering gkn v 405520 02 384 stamped on the outer round edge , no other stamp markings found, 55reg td4.

Fixed running issues with engine thanks to lynx diesels. Highly recommended

Hi all, update for the problems I 've been having 4 injectors been refurbed by lynx diesels as recommended by rover Ron.now running sweet again.

hi hd3 thanks for reply as i said booked in at main stealers, mechanic there told meabout a mech/tech that had left there to set up himself so i give him a visit, he hooked up to t4 diagnostic that showed 1 injector out of spec at idle and 1 injector out of spec at 1200 revs different...

hi all , having engine running issues 1500-2000revs engine knocking rattleing not all the time., can run for days no problems then next day its there, went to main dealer to book in for diagnostics check can only do it next week,while there i was talking to a mechanic/technician he says its...

Hi , I got my full set from dingo croft 4x4 £170 they also sell t he complete set of bolts but if I was doing the job again I would only buy the rear hub crossbolt it's very hard to get out in one piece all the rest of the nuts and bolts came off easy mine was on a 55reg td4

Just completed full polybush on front and rear suspension rear wishbone bush bit of a pain to press in, all the rest easy to press in using 12mm studd Ing and sockets and liquid soap, also done 4wheel alignment , completely different ride now for the better , hoping to fit the second hand tank...

You'll need to raise the front to do the arb bushes , the rh s bush easy to get to, lhs bush not as much room to work on, wo rk the bolts 2 per clamp with plenty of releasing fluid can be a pain to get out can easily snap the bolts being well and truly rusted, snapped bolt sub frame off

Thanks for the quick replies I'll check the rear tie bars.model 2005 td4