Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. D

    high tenp engine oil

    .
  2. D

    high tenp engine oil

    Yes. every day, i drive a 20Km hill from 7600 feet to 9200 fet over the sea level at 60KM/h and i get the hot oil temp reading. the oil I use is w20/50
  3. D

    high tenp engine oil

    in my 1975 rr i get a high temp reading (very close to the red zone) while the colant temp is nornmal. i was playing with the ingnition timming, I fix this at 12 before. keep in mind that i live at 12000 feets over the sea level and the distributor is a HEI (accel). My 1987 rr is set at 10...
  4. D

    Lifting my RRC 1" self leveling unit question.

    I have lifted 1 " my rrc 1975. My question is, I can mantain the self levelin unit orI must extract it? Usually I tow 1 ton trailer.
  5. D

    RR Classic oil pump question

    I must change de timming cover in my 3.9 EFI RR. but I can get only an earlier timming cover (for an 3.5 EFI). One of the differences, that one that worries me, is the oil pump gears. The gears in oil pump for the early timming cover are smaller than the latest. My question is, can I use this...
  6. D

    air bubbles in an overheated motor

    Thank for your help. There is no more bubles and no overheating. I apologies for my late reply.
  7. D

    air bubbles in an overheated motor

    Yes I have all stardar pipes.
  8. D

    air bubbles in an overheated motor

    I overheated by 1987 RR so the cyl head was rectified and the old head gasket was replaced by new ones. Now when I start the motor, there are some air bubbles in the radiator for at least 30 seconds and then disappear. Is this normal? The temp is normal and there are not water lose
  9. D

    3.5 or 3.9 inyectors?

    In my 3.5 EFI 1987 RR a month ago I put a new 3.9 block. All the 3.5 anciliary are the same I used in the 3.5. My question is: Is necesary to fit inyectors made for the 3.5 or 3.9? (they have a diferent part number, may be the 3.9 inyectors pass more fuel?) thanks. diegol
  10. D

    fuel pressure regulator

    I need a new fuel pressure regulator (err268) to my RR efi 1987. I cant find this part number instead I have part number ETC8494. Somebody know if I fit this fuel pressure regulator (etc8494) to my range rover 3.4 efi (whitout catalytic convertor) wil work fine?? Thank for your help. diego
  11. D

    Any ideas on this one? coolant levels low?

    In my RR 87 the low coolant warning light in the dash never came on (either the expansion tank was full or empty) so I repace de Sensor/switch that is located into the expanstion tank. Now the low coolant warning light in the dash is ever flashing red, like Chris problem. I know this is not the...
Back
Top