Search results

What I noticed was the old bulkhead has a hole space for the mechanism that runs from the wiper motor to fit through. That is directly under upper frame work dash sits on, the newer bulkhead does not. I will check size of holes tomorrow, wiper motor screws are loose but a wiper is frozen. Until...

Thanks I am hoping to get both bulkheads to a welder friend by summer? Then determine if saidwelder is willing. Next up is removing the wiper motor & the wiper assembly see if that will fit. I believe I have one frozen wiper arm see how long that takes. Evidently need to make room to access the...

This is a picture of the bulkhead in 84 110 PU of the wiring loom through to engine Bay Area. Still in truck, the sills were welded to bulkhead very rusty footwells so on. 4D6D620C-8694-42A9-B205-9EB3EE03A949 by seaswood, on Flickr This is a picture of the donor bulkhead no through bulkhead...

Sender you measure the ohms or resistance when inserted in as said above hot water.

The oil gauge in other truck I have been un able to get to work. Everything checks as it should, it is basically same as voltmeter reads electricity what comes in & goes out? I have weeks figurung out the wiring.

Hole to right blanked out looks like a plug made to fit, what would have been in that hole? Or that was an option. C58E349E-390E-4121-B97E-0B39FFACCEAA by seaswood, on Flickr

I have been trying to sort out why the oil temp gauge does not work for too long. All the parts test as they should, continuity, I need to look at it again. But you have a voltmeter, trucks I have do not have voltmeter.

Like you said just to pull things around the yard.

I have old winch waiting someday & would prefer one battery. On this side you see a lot of double batteries, but yes what for.

The starting battery is also the winch battery?

Originally a soft top you say, it is a 110 3 tub.? The holes were crudely done for speakers! Will need patching. unfortunately the sills were welded to bulkhead so that is slowly coming apart, why I was asking about switches. I will need to go through all the wiring for any bad areas...

C34FEFD0-D452-421C-A0AC-FDBAB5329707 by seaswood, on Flickr

Pick up rear opening for what we call a tail gate you may call tail board. What you may cal the floor in the rear.

Thanks, the opening for the bed was modified at some point assuming some thing was fitted to rear bed?

Thnx the Xmod does not have that option.

Rear heated screen this is a pickup? the interior light switch is a dual switch not sure what other side is. Thnx yes coming apart so disconnecting fixing repairing

What are these switches, 84 110 I have put in a hazard & running lights on a later 90. These are tho done nicely original, as this comes apart nice to know. Hazard in center R & L is? 490A5131-2767-48C1-AF87-328A5E6F20CE by seaswood, on Flickr

The fronts you sorta need to push the axle down enough to get it out watch them fingers. I had to Jack frame up to be able get axle down enough. Both wheels off. The shocks are likely to be more work as they need to come off first. Rears are easier as shock is separate.

Thanks The olive & nut some fuel hoses arrived, I looked at & did not think they would work at all. Installed shocks then I tried the connectors & they do work. The fuel supply level unit measures 8 mm either I cut off the end or just replace with new as end is distorted to fit olive. The...

You sorta have five to ten nano seconds to get the final top cap in place & get the nut started. I had left the assembly compressed over couple of nights, plus using a flat washer for compression.