Wiring & switches

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
The tub floor on a landrover is an alluminium sheet that is riveted to some cross struts which you can easily see from underneath.
I don't think was anything fitted to the floor in 1984 ?
If you drill out the rivets you can ease the floor out, i believe that YRM do a 2mm or 3mm replacement.

In the early S3 there were no door switches for the interior light, the switch on the right in your pic is for the interior light and the dash lights.
The switch on the left is for the heated rear, safari door, window.
If you have a pick up/open tub now they typicaly came with a (drop down) tail gate, if the rear door is side hung then it's likely to have been cut in half when the top was removed.
Original pickups often have cleats along the rear tub capping when the tilt was tied onto.

Post some pics ....
 
Just of interest, where the plates are riveted on top of the wheel box's it was possible to have a shaped holder for the spare wheel usually behind the driver [ mine was like this] with a clamp to the side rail. A tool box could be fitted the other side.
 
Originally a soft top you say,

it is a 110 3 tub.?

The holes were crudely done for speakers!
Will need patching.

unfortunately the sills were welded to bulkhead so that is slowly coming apart, why I was asking about switches.
I will need to go through all the wiring for any bad areas.

tailgate was bent I have a good one & a lift gate should I go that way.
 
You must log in or register to reply here.

Similar threads

Seaswood
Bulkheads
2 3 4
Replies
63
Views
6K
Seaswood
Seaswood
MrWorf
LED daytime running lights & work lamp
Replies
16
Views
2K
v8250
v8250
M
1985 90 Rear wiring
Replies
2
Views
1K
MelancholyDonkey
M
Margo Ledbetter
Newbie query about 90 lights
2 3
Replies
44
Views
4K
yfo866
yfo866
styleruk
2.25 petrol rough idle
2 3 4
Replies
60
Views
2K
styleruk
styleruk
Back
Top