Search results

Ended up getting a LHD cable in the end, its done the job!

Ive been trying to find a new accelerator cable for my 92 RRC 200tdi RHD, But according to Rimmer Bros they are now obsolete. Paddocks only seem to stock Britpart so have been browsing the web for an alternative. But have the usual problem of parts compatibility charts saying it wont fit when...

I am now feeling really stupid and now and after this post I will go and sit in a corner for a while in shame! My blower was trash so replaced it, but my confidence in electrics is zero. So when the new Item arrived with different plug and wire colour I wired it up to whatever logic I had at the...

New resistor pack finally came. All fitted, decker panel back on, dashboard back on, Tested heater controls and now works on all three settings, revved engine and blower didnt come on, so went for a drive. Once again when I start climbing a gradient on comes the blower motor, and my rear drivers...

Ok so replaced the restrictor in the heater box but still had the same symptoms. So took off the decker grill for a peep inside. Found another restrictor, although this one has an external copper wire wrapped around it that was basically non existent in places. 4 spade clips with one totally...

Mine was just hanging out of the blower unit? After your comment Ive had a google on RRC HB Resisters and they seem to vary abit. Someone had been inside the dash on mine before as many of the screws were missing and the Blower unit was missing its most difficult bolt! This is similar to the...

Yes I did check fan speed and it was only working on the highest speed. I figured I would sort that out in a week or so when weather was better. Didnt think it would cause a prob elsewhere, for the time being. (Should of known better with electrics). Ive been reading about the resistor, and...

I have just replace the heater blower motor and matrix in my 92 200tdi classic. I taped all the connections and marked them before dismantling, Took it for a test drive today and the blower only comes on when switched to level three. But even worse it also comes on when I accelerate???????? Any...

The gaskets always seem to be a few mill too short and will never sit right in the first place? Only had this prob with the 200tdi? I have to stretch them, but then they often twist. I think this is what keeps happening as it keeps leaking just after the curve at the end of the cover. This will...

Hi based in Ceredigion.

Yes will do this time! Everyone has always taken the mick out of me for my obsession with my Landys "NOT" having oil leaks, but over the decades Ive always managed to have non leaking landys after a wee bit of work. So its become a bit of an obsession with this one. lol. Even if it kills me I...

I think I have found the prob? or at least the latest symptom! The rocker cover gasket has misaligned at the back and is bulging out. Ive had alot of problems with these as the old britpart one that I was saving for dire emergencies ripped in the same place. But that and the 3 Bearmach gaskets I...

Thanks for the replies, I forgot to add in my intial post that its a 200tdi engine. I was thinking that all the symptoms seem to suggest a blockage of some kind. When I remove the rocker cover all is fine inside, The oil is still clear and only slightly tainted with carbon. I had replaced the...

Am really losing the will to live with my 92 RRC. Any help or ideas would be appreciated. Approx 13 months ago I rebuilt the engine using a reconditioned bottom end. Once back together it was leaking oil from inside the bell housing. So I assumed I had not fitted the crankcase seal properly...