Search results

You could try rocking it in gear see if fan moves. Or quick flick on starter

Must have an understanding wife or you sent her away for a few days 😀 Does look very nice and worth the time put in, well done and time to enjoy now when the summer comes

You can change the speedo calibration

Brown onto inlet manifold looks weird they’re normally live so that would be a direct short Wait a bit are all s2 positive earth

That’s the one under passenger seat I fill directly into tank but assumed they all had drain plugs

Once separated from the cradle, I filed holes with fuel tank epoxy then a layer of fibreglass on the base , but you could do all over with a clear coat of epoxy

That’s sounds a bit more than workshop manual spec of 0.15-0.27mm measured on the crown wheel

As tottot says make a level platform some 8x4 ply would help, but how far to get it to workshop To strip properly and over what ground engine crane not good at distances unless ground smooth and level, the block itself manageable by two carrying it but not walking far , maybe an option to strip...

Looks good how much was yours

Sep 21 from Blanchards it was a Denso good quality

Back to your original question wasit worth $4700 ,bidding with 50mins to go is $8000 Looks very good, but compare to one in A1 condition over there to see what they could fetch. If it drives it could be roadworthy for little cost and then a rolling restoration if you want to . But most of that...

Have you seen it in the flesh, any pics, there’s lots bits to check and consider to decide whether you want to take it on, if you did meccano as a kid you’ll be fine

I put blue box swivel balls in 2018 based on peeps saying their quality was quite good, not disappointed so far

Do the headlights come on when trying to crank when warm Have you got clean brass on the connectors going to starter and tight ( cleaning earths is good do the same with positives) Is the small wire and terminal to starter solenoid clean and sound is the connections to ignition barrel sound and...

My 84 is just unpainted ally, I believe that’s original

Have you got the correct seal too, and do you know the additional over glass measurement reqd., it looks with the seal very close to gutter and inline with one of the tub hooks. I would have it so edge of seal is just above top of gutter to keep the wet out

It is and looks a bit knackered

https://www.johncraddockltd.co.uk/aeu1045-girling-reservoir-on-brake-master-cylinder-various-apps.html Is it same as this for dual line master cylinder , sometimes you buy the mc and the reservoir together

The bundle of connections should be covered by the the little corner cover if you have one

It’s the thin slot of the two in the flywheel you want, was that the proper timing pin fully in, it looked very wobbly, mine was a neat sliding fit