Search results

AJS list this one for the FL1, which is a comparable spec to the muddy mods one. https://www.ebay.co.uk/itm/225752951352 Probably worth messaging them to check though as the picture they have in the listing looks like an early FL2

I want to like AND dislike this post at the same time :p

Following research, I believe that the rear requires four of ANR5335

There are large-ish gromits on either side of the bulkhead, one behind the engine bay fuse box and one below the brake servo

Looking great! What make intercooler did you fit?

2nd hand IRDs are risky. What's the shipping cost to France for a reconditioned one from the go to people (https://www.bellengineering.co.uk/)? Might be worth it if you're keeping the vehicle in the medium/long term

Mine has been standing for nearly three months now whilst I sort a number of issues, but took it for a drive a couple of weeks ago and loved it!

Does seem a bit odd. Surely it's worth spending the £180 to get the welding done, and then flog it with 12 months mot on? If the welding was £500 or something I'd understand

I've had this a few times. I remedied it by bending the contacts in the holder a bit. I think they go a bit soft or less springy over time. The first time I had it I was swapping bulbs over and checking fuses etc but realised when swapping holders over that it was a holder issue.

Well that's a bit wierd because a couple of weeks ago on my PC it was an FL

Nah, It's only dissapeared in the last couple of weeks.

These guys do the cables and facia adapters that you'll need depending on if you have the Becker unit (HSE and Sport Premium models I think) or the standard unit - assuming it's a facelift?. There are a few threads on here about head units, both android and conventional. Do a search...

This depends on if you want an unblemished motor. It certainly wouldn't be a write off if the only damage is to the bumper and nothing behind. Second hand bumpers will be between £50 and £200 and you might get one the same colour. An insurance job for new bumber and spray would probably be...

It's not conclusive but @Arctic2 has info on it. I fitted a RonBox probably around 2014 Original (assumed) pump replaced May 2016 at roughly 108k 2016 pump replaced June 2019 at 135k 2019 pump replaced Feb 2022 at 160k. RonBox removed 2019 pump still currently fitted, 185k Remap is your...

Went to give it a run today, but the battery was flat. Jump start and run at the weekend I think.

Where's it gone? There's a funny looking boxy leaky rusty thing there (would still love one obvs mind).

First I'd double check the fluid level. There is a strict procedure to follow to get the level correct - warm gear box, engine running, cycle through gears, top up until it weeps out of the level plug hole. I wouldn't bother with a RonBox. Anecdotal eveidence says it knackers your HP fuel pump...

I'm thinking a couple of plastic bags filled with sand in each depression would be better

I don't know for sure but I would say highly unlikely. It looks quite a bit wider

Scrap yard is your best bet, but nearly all of them will have perished rubber outer casings, unless they've been garaged from new.