Search results

Hi, i want to put a fuel injector cleaner in my td5 engine. Can anyone recomend or advise to avoid as the injector set up being a little different to most diesels i have worked on. I had a turbo go and thus a lot of oil was sucked up and burnt. The car is now running great (with new turbo and...

Hi all , has anyone got a Nanocom in the Hampshire area that perhaps would not mind me having a diagnostic check of ECU (my electric fan is permantly on). My car is a disco 2 td5 1999. Or has any one got a nanocom that they might be interested in selling. I have phoned a guy from southampton who...

While taking rad and intercooler out i noticed that the power steering pipes that run underneath rad were badly rusted and i purchased new ones and then went about fitting them and filling and bleeding the system. I noticed that the fluid was very cloudy and looking through the history it did...

With the engine stone cold, as soon as i start ,the fan comes on. Temp is all normal on dashboard and when i pull relay out of the engine bay fuse box the fan stops and then starts straight awayupon replacing it. . I have tried swaping the relays over but it make no difference, the fan just...

Hi, air con fan on the front of my td5 is running all the time even when climate panel is switched off. Is this normal?? If not any ideas were i can start to look for faults Cheers all

Hi all, i have a td5 disco 2 and want to flush the power steering fluid, has any one done this or can recomend a safe flushing oil???

Hi i had quite a bit of dealing with these and in the end i replaced both air bags put them on the car and also could'nt get the compressor to fill (dont forget though all doors windows and bonnet have to be shut to allow it to run). Basically there was loads of air built up inside the...

Hi all, does anyone know if a nanocom can be used to re program say injectors on early type ecu ie non flash /?. Cheers Mark

Yeah ,i was told yesterday (by distributor) that nanocom are no longer making it and they have had to source new item (the hawk eye) so i dont know if thats the end of nanocoms for td5, or there just not making that model anymore and distributors have had to find an alternative

In particular i would like to check and adjust fuel on injectors and also i need to calibrate ride height sensors of rear air suspension and carry out a general health check on engine.

Hi, has anyone got a Hawk eye or Nanocom in Hampshire area. Ifso any chance i can disscuss possibly using, or is anyone 'up on ' these that perhaps i could have a mobile contact number, as i am considering buying but every dealer i have spoke to just refers me to the manufactures web site which...

Hi all i,ve read up on how to set up mechanical clearance of rockers to injectors but with regards to the setting up of the electrical side do i have to have the injectors re-programmed at landrover dealer or is it time i brought a Hawk eye /nanocom ,will nanocoms not do this.? I have just put a...

Hi again, cleaned all the bits and taken turbo to bits . I want to run engine with clean oil and somehow slave the turbo exhaust side up by putting blanking plate on turbo and thus just using it to complete connection to exhaust. Air inlet side will just be open but what i want to know is should...

Hi all well took turbo off and removed intercooler(full of oil) and inlet manifold,taking sump off tomorrowry and see if anythings gone in there. I am gonna clean all parts, connect it all back together with fresh oil and filters, some how by pass the turbo oil feed/drain slavingthe nakered...

Ok chaps! what i mean is, it's not just bolt a new turbo on, or is it ? Is there likely to be futher damage to engine. i appreciate i wil have to put fresh oil and filters etc.

Hi all can anyone help/Advise. On my way home on the motorway tonight came off and drove up slip road and i noticed no power, went to pull over, looked in rear window and could not see anything .........She was smokin and a mean smokin, turned engine off and engine continued to tickover, then...

Hi sorry to hear that mate, is there any unique marks on body etc my eyes are open Mark

Ha yeah Know what ya mean, said that i wouldn't mind doing clutch over Christmas break and wifeeeeeeee said i thought you were doing egr removal, injector loom, remap, full service i mean you've had all the bits in the kitchen long enough now!!!!!

Hi looking to put new clutch in my 1998 td5 and probably put a new flywheel in as people keep saying whike your there it is a good idea (dual mass flywheel) Has anyone done this job at home on drive or is it a ramp job ? want to do it myself as i guess this would be a lot of labour money in...

:)Cheers for that, your site is simply the best and i'm of to my dealer tomorrow to get all cruised up! Probably do the injector harness thing soon as well and i note that you reckon a gen rocker gasket is far superior to a/market . Mark