Search results

Hopefully somebody has had this problem, I ran my freelander with all 4 wheels off the ground to identify a transmission fault ( which I did, now repaired! ) but now I have the 3 amigos, Ive checked the wiring to see if was stretched when the suspension was fully extended but it was perfectly...

Fitted a tailgate door handle!!

Changed the aux drive belt and tensioner as they were very poorly and making a terrible noise!

Twin alternator? Why do you need 2 alternators? Sorry if its a silly question I'm just curious

Well I've just got back from a 3 week holiday around Europe, in that time we have covered 2800 miles towing a caravan all the way. We have been in scorching 38 degrees in the south of France and below zero with snow in the Swiss alps. We have been on countless miles of motorway and up a mountain...

happy days! :) glad u got it sorted

It sounds like they are back feeding each other, there will definitely be somewhere that these wires are joining together if it isn't the bulbs then check all the areas the wire could flex or chafe, if the wires are fine near the back lights (which is the most likely area) try under the dash...

that may well be your problem! :) It may just need adjusting or you could have a leak at one of the hoses or the intercooler and/or exhaust could be a bit blocked.

Hence the reason I asked, I wasn't sure if the ird was the same for the petrol cars. So it's all good then :)

is the diff ratio the same?

a garage will just use an impact gun, if that fails they will use heat to get it off. Try chiselling the nut round, sometimes it needs the hammering action to free it off hence the reason just a bar wont always work

mine sits at around 3000rpm doing 70, gearbox wont bed in it must have a different 5th ratio. My concern would be that if the 5th ratio is different is the diff ratio correct? Is the box the correct box for your freelander?

I would certainly be looking at the boost pressure, low pressure will cause it to smoke, it could even be a blockage in the exhaust not letting the turbo spool up properly.

I made this from an old chair, the finished article has hooks on to put a ratchet strap around the wheel and hold it on. It works really well :)

deffo bad earth probably in the actual light units themselves, try running a separate earth for your trailer indicators and/or side lights also try giving the trailer socket a good clean, take it off and check where the wires go in it will probably be full of rust and crud.

well there you go I've learnt something today then, well I shall change my comment to I banged the DOC and it didn't rattle! lol

Well this rattle is doing my head in! I am going on holiday at the end of the week so I am trying to sort it out before then! I have a rattle that when free revving the engine comes at around 3000rpm and goes around 3250rpm when driving it sometimes appears under load and on overrun it seems to...

Lol all good thanks just been made redundant so been busy trying to sort stuff out, getting ready for our hols next week so been pretty busy. I have got the most annoying rattle around 3000rpm and goes around 3250rpm but is also present on overrun so Ive been trying to find that but to no...

Possibly the starter relay or a bad connection, both cheaper and easier to start with before you change the starter.