Search results

Thanks Falk I do have a problem with the battery going flat after a few days ,I will change the battery for 100 amp one at sometime but the existing one is almost new .At the moment I make sure I run the car for a while every couple of days .

Thanks quavey I will have a look but I think it's more likely to be me being a pratt .I just panic with this car .

Right Folks ignore the above ,just went out to the car for another look put the key in and gave the gear lever a push it moved forward slightly and I mean slightly and the car now start's it was not right into park .What a plonker ,the trouble is I read about all the problems and what can go...

Hi Folks I need your help again ,got in from work this evening went out to move my P38 it opened with the fob no problem put the key in the ignition turned it on no problem , turned it to the start position nothing not the click click of a flat battery ,but the check engine light is on .I have...

Thanks for the replies folks ,I will let you know what I decide on doing .I would like to see a photo of your tablet install Pete if you don't mind that's what started this little job off ,trying to free up the socket in the console so I Could fit a tablet.

I will have a look under the dash on the passenger side.WIsh me luck.

Discool I am worried in case someone else was to plug in my 12 volt compressor that is in the boot or something with a heavier load than I had anticipated these cars seem to have problems with the electric's just don't want to risk it .Ukadamwest and tnseal THANK YOU both I will do exactly as...

I did think about connecting into the existing socket I am a little worried about over doing it with the wiring.I was going to put a 30amp relay in the engine bay triggered by a ignition on circuit .

I would like to fit an additional cigar socket by the passenger seat for charging my phone and other bits and pieces as the cb is in the standard one ,but I cannot see an easy route through the bulkhead for the wiring .Has anyone found a route using an existing sleeve or other,I don't really...

Thanks for the reply's, I am far from a Whippersnapper used to have a set .I will fit the thing and see how it pans out if I have to I will get the brackets made up sounds like it may not need them.

I have managed to get an A bar, bull bar, nudge bar not 100% sure of the correct name it's the plastic Landrover one for my P38 just the centre A section.I have the brackets that bolt on above the bumper and to the back of the A bar plus the spot light bar should there be something to secure the...

Hi Folks just like to say thanks for getting me out of the brown stuff yet again.

Don't like the look of those kinetic ropes ,there are some on utube they always seem to end up throu someone's back window .

This is a bit off topic but I thought if any one would now it would be you guys ,I would like to go and watch an off road event .Is there any held in the eastern area, we had the TMX for motocross events is there anything like that for 4WD ?.

I have a Landrover tow bar with detachable hitch on my P38 ,I would like to put a shackle on the back as a recovery point does anyone know of a fitting that can be put in the receiver to take a shackle or do people just use the holes that the bolt goes through ?.

I must say I think what those guys ( Jai and Lee ) did yesterday really was above and beyond ,its nice to know if you are in deep tish there are people on here that are prepared to help you out .F.A.B Jai and Lee well done .

:lalala::rolleyes:;)

What time are they going up there?.How did they get stuck on that lane its as flat as a witch's tit .?

Hi Datatec Try as I may cannot get the software to work three adaptors later ,35 mph warning comes up that's it loads of message,s ie this port is not open ,your click has failed ,you need to use the drop down box and others.I bought the kicker plug in works great out of box going for the...

Hi Folks Anyone know the situation with the guy that's stuck I am about 20 mins away if I can help . I have only just seen this or I would of offered before .