Search results

I seem to be getting conflicting answers, I bought new Valeo blend/distribution motors quite a while back to replace the distribution motor. The distribution one seems to have gone wrong. I am still trying to find the cause or if it has in fact gone as there are no faults shown. Are these motors...

And thanks for the response Keith

The recirc motor failed due to a jammed flap years ago but for some reason is now showing a fault after doing the "O" rings and stripping most of the dash out. Pity about the blend motors not being the same, I still have 2 brand new ones! I will have to strip the stuff out again and have a...

Ta for the info, To continue, somats up, I can calibrate as mentioned previously with no issues, however, I have forced the distribution motor to face level but it stays blowing at floor level. Therefore I assume that the motor must be at fault although it doesn’t say it is. The recirc flap...

Would that not flag a fault on the nano when doing the calibration though?

Hi Keith, I have tried both, the same on either one it just seems to send it all to the bottom vents

The saga continues, book symbol now gone and no faults showing, however, there is hardly any air coming out of the face vents. The distribution motor is working as are the blend motors, I have calibrated and tried them under the Nanocom with no issues. Both blowers are running fine. I am...

Before I take out the glovebox etc how accessible is the connector for the LH recirc motor (RHD car). This is the only fault that the Nanocom is showing. I have a good spare motor and was thinking of plugging it in and just zip tie it to something to fool the HEVAC into thinking it is ok. I know...

That's what my old girl looks like today, however, it is for the "O" rings. All done now, what a ball ache of a job!!!!

I doesn't pull dry air in, it drys the air when it is operating, it only blows cold when asked to (sometimes you have to plead with it) the temp will be at whatever you set the control to. You will sometimes find the moisture it squeezes out lying in the footwell if you dont clean the drain...

That would be Paul Bennet that did the decals

Try Craddocks, that's where I got mine, ain't cheap though, James Coleman on the P38 Facebook group may have a good used one ALR8602 or ALR8603 for the rear doors

You will alert the central scrutinizer (If ya know ya know)

Cheaper do do it yourself, I would imagine you will have a one piece. The 2 piece is easier to manipulate but doesnt look as good as the real thing.

I had my unit (Clarion) modified with the external jack, I have a mini Bluetooth adaptor so I really only use my phone or the little DAB unit I bought a while back. I stopped using the CD player years ago, it still works but as with any cd player can be a bit flaky over bumps and the proverbial...

I am sure you have already done it but I had major issues with my HK door stuff, although I had cut and soldered the larger white connector behind the LH kick panel I hadn't done the smaller one which feeds the outstation. After soldering all was a-ok

Two are even brighter..............

You do have to remove a bit of material to fit it, easy does it Homer

It does actually make visibility a lot better, as Keith says though, sometimes a tad too much, LED light is unforgiving!!!

I just put in Y connectors and tapped off of the one lamp, even colour coded the additional wires :)