Pressure tested the AC last week with UV dye and the condenser looks like an 80s pop star that had been shot with a shotgun. Holes everywhere. New condenser fitted today, regass, evaporated temp down to 1°.
Now we'll have 6 months of rain and cold.
I are on the road of togetherness.
The other swivel got demolished so the spare i got to replace the moog on the other side is trying to go on. Unfortunately the bolt holes don't line up, but i have a file. Job for tomorrow
Not used the 38 for 8 days I think as i needed a work horse as i had a house roof replacement to do so used the 110. Battery flat on the 38 this morning so that's on charge and decided to fit the new genuine tailgate seal. The difference in soft...
replacing the front control arm, the straight one with the height sensor on, the ball joint is dead.. that wont come out either
did manage to persevere with getting the CV/axle out tho! thats definitely a 2 person job. might be easier on the...
Check the brake switch using Nanocom. No need to drive around for this. Here's my Wabco-C but the brake switch wiring is the same. Switch-1 should be normally closed, and open when the pedal is pressed. Switch-2 closes when pressing the...
Check the small pipe that goes from the top of the rad to the expansion tank👍
The cap on the expansion tank can give up as well but then the coolant would run towards the bulkhead🤔
ok, the problem is solved for the time being.
unfortunately I didn't proceed systematically.
what I did:
- pulled out all fuses (including those in the engine compartment)
- checked - all fuses were good - treated with contact spray
- Checked the...