Spend 1/2 an hour on ebay and check what the parts alone are worth.
S2 wiper motors good money
200 tdi decent money
Galv chassis good money
Then think of a number and see what they have to say, remember you can always go up.
If they're in riv nuts, my money is on the riv nut spinning before the bolt remains come free.
Before you spend a whole bunch of time on it, I would suggest making sure that your new fuel component mates up to the fuel lines perfectly still, as...
What happens is the oiltite bearings run dry and seizes ono the motor shaft, then the bush starts to spin in the motor housing dry and basically shags the whole thing.
I tried to strip mine, gave up and bought a new one.
Final update: After replacing the temperature sensor and thermostat on my 300 TDI, I discovered the 3-way splitter on the overflow line was misrouted, sending the main coolant flow to the expansion tank instead of the radiator. Correcting the...
This is my build here: https://www.landyzone.co.uk/land-rover/200tdi-s3-88-pas-long-travel-suspension-rebuild.298104/
Having also got another 200Tdi powered Series, I'd also suggest moving the alternator to the other side of the engine. Gwyn...
Been jump started during the repair?
Tried disconnecting the battery then joining the negative and positive battery leads together for a few seconds then reconnecting the battery?
Greetings. I thought I'd try and get a discussion going about problems - and the solutions to those problems - that your Landy might have in the cold. I have an '05 90 Td5 and I live in the Canadian arctic (but I'm a born and bred Brit so I feel...
Still might be salvagable, maybe pull it apart and take the parts to an engineering firm to see what they say, but a known good or reman engine might be the better bet.
Not sure where you are in the world you are? but I can highly recommend the...
Looks like you may be right. Lots of evidence inside the block, including more JB weld, a nice gouge in the crank and something dented and scraped the upper portion of the sump. All the con rods have too much end play, can hear them move when I...