Grrrrrr's latest activity

Bottom of both those gaskets look pretty bad to me.

It's to cool the gentleman's area... The same on mine. I just taped the tube up and refitted as best as I could 👍

I would imagine less power if elements are failing as they won't be in the circuit anymore. Some of the lines across mine have failed. I need one of those pens with conducting fluid to join them back up again.

...a small addendum. The new one wasn't delivered - delay... So I pulled the pin out of the old one, pressed the brake pedal and put the old one back in - and lo and behold - everything is great again. Thanks to everyone for the great support...

At the rear? Switch under the pedal needs adjusting or replacing.

As above. My rear one has started leaking so I am going to have to do the same job. At the risk of hijacking the thread, on tightening back up does it have a sort of crushable washer or do you just mark everything up and tighten until the marks...

The vibration could be that your front driveshaft is not phased correctly. The u-joints need to be installed slightly out of phase. Could also be pinion carrier bearings, can you feel any play in the pinion when jerking it around by hand? The...

If the diff flange is worn then the seal won't seal against it. Also the seal is different depending on what mud shield your flange has. I am presuming the diff is the same as a Defender, if not ignore me.

Normally you put them in, lower a bit on the jack and make sure the bag is folding over nicely, let it inflate slightly then pop the boot and adjust as necessary, then lower a bit more. Then shut the boot and hopefully it will lift itself off the...

Once is enough. Could be worse, xould have been Mexborough.

I drove her over the hill and far away. Ok not that far away, about 30 miles. BUT she started with ease every time I had to go do something. I know it's foolhardy but i feel so confident in her starting, I've actually gone on standby. o_O🙏

Right you were. Snapped one of my sock size adapters last night. But the good news is I've got the passenger side head off, after much swearing and knuckle scraping. Now it's just the much harder driver side left. I've taken the wheel arch out...

Rear screen relay is in BECM as you say, but front has two relays in engine fusebox. I would suspect connection issue from HEVAC output to the BECM. Maybe bung an inline fuse thingy in place of F12 & see if the current changes with the...

Done some more investigation into the failure of the fob receiver that's under the headlining.. it's obviously got very hot, the marks are where melted plastic from the box have transferred onto the circuit board

Finally! Turns out it wasn’t really the image file size, but the pixel dimensions - go figure. Anyway, a clean P38 for you all to admire.

I am glad Airtex is being mentioned i fitted that make to my Renault master van the weekend and went with that make as i had heard of them:)

I fitted airtex to gems, with metal impeller

Willing to swap my P38A for it if you chuck in a full tank of fuel?

Lead? Presumably the flashing around the windscreen to keep the rain out?

Sorry for the late response life has got in the way. I am using a Snap On Solus Pro . Thanks for the diagrams I will get on it as soon as I can and report back. Thanks again for your help Gary

That might be my next problem but I'd like to have a radio to drown the noise as it dies.

At lest the crank hasn't snapped yet.

So a Disco 3 then :)

My old P38A ones are probably in a box somewhere if they would do?

Just click on the picture icon and then browse to the photo and double-click as far as I remember.

Might have put early L322 wheels on. Or they might be Disco wheels. The former need a spacer.

grinder? dremmel?

Depends on the seller. I suspect some is seconds or stuff that failed quality control. Other stuff they stay on late at work, knock another ten out and then sell on from home. Of course, they may not have the help of be adept at all steps in the...

All this talk about having a good tug :rolleyes: There was a time we'd have had some mileage out of that😁😁