Recent content by BarriKuda

Thanks Arctic and Nodge, I can now get the correct service kit, cheers

Could someone please tell me which gen haldex I have, I have a 2008 FL2 HSE, thanks

Bit of an update here to this fault, when engine has cooled down and fluid is cooler there’s no problem, it was a hot day here today 25c does anyone think that would be an issue, very confusing, thanks

Bit of advice please, power steering getting stiff and lumpy at low revs ie tick over but ok above 1000 rpm, no loss of fluid. I replaced steering rack, pump, reservoir and both pressure pipes last September because I’d lost a lot of fluid from reservoir and there was a load of glitter in...

Thanks chips, I’m taking it back to garage that replaced drive shaft so that they can fix it, they’ve said they probably nicked it while fitting new drive shaft

Thanks buddy

Sorry that should be LR003155

can someone confirm this seal part number for me please, I believe it’s LR3155, I have a F2 hse 2008, If the picture is not clear the seal is gearbox to drive shaft near side front RHD, Thanks

Bit of an expensive Xmas then

I forgot to add timing belt when I first bought it, seller told me it had been done but I had it done to make sure and I noted the mileage when it was done Barry

Just gone out to start it and it’s started first time a treat, go figure ha!, not quite as cold this morning, I forgot to mention I checked battery terminals and put it on charge just in case when I first got it started yesterday Barry

Could be but only done it since it’s got very cold, I’m thinking about taking it to Freelander specialists in Methwold, they’ve done all my big jobs so far

Yes love mine too, I’ve invested a small fortune in it, new transfer box, flywheel and clutch, haldex and diff bearing, wheel bearings, steering rack and power steering pump, it’s now cost me more than I paid for it but it’s an old car 2008, I don’t think the mileage is correct I plugged in my...

Thanks l hope he notices too