Make sure that the model you choose is ok to carry people in the back before you buy it. There is a lot of chat on here about carrying people and children in the back of a 'van'. A 110 is far more practical, cheaper to buy ( unless it's a CSW), a better ride and not really any worse on fuel...

I agree with @rob1miles a series is cheaper to run if it is MOT and Tax exempt and perfectly useable if you only go 'local'. I have a 2a lightweight, I love driving it around but the furthest I take it is 7 miles to the LPG station. Whereas my 2.5 n/a 90 whilst 'slow' by modern standards, I am...

Yes you're right, I didn't read the post correctly. That said the panels the OP wants are going to be from a series either 88 or 109 and then being fitted to a series so it shouldn't matter.

All rear doors from 1958 to 2016 are the same size. Older doors have non anti burst locks and newer doors have glass held in by rubber strips, not angled Ali and 35 screews! So I don't know why a 109 door wouldnt fit your 88.

Ebay has some: https://www.ebay.co.uk/itm/Land-Rover-Station-Wagon-Side-Panels-With-Windows-Early-110-Or-109/143791022524?hash=item217a9ce1bc:g:QAAAAOSw6OlfifCl The ones from a 109 (LWB) station wagon are the same size IIRC

2.6 straight 6 - 86 bhp @ 4500 rpm and 131 lb/ft torque @ 1500 rpm. It was only 7.8:1 comp ratio. It is possible to fit a 'Westlake' head from a Rover P4/5 to increase power but some variants require the modification to the bellhousing iirc. I bought this one a few years ago, but it was too...

Your right, my bad

Some of the new replacement light units these days are of varying quality, Ive even had them wired incorrectly, Ie tail light wired using the brake wire and vice versa. Don't guess, test, as said above swap bulbs first, then check the earth but the tail light used the same one so it might not...

The correct brushes for the wiper motor are still available and are not that expensive so I personally wouldn't bother. See here...

Have you done a compression check? If your valves are burning out due to lack of leaded fuel (or lack of additive) that would affect power and running.

https://www.ebay.co.uk/itm/LAND-ROVER-SERIES-3-FLYWHEEL-HOUSING-2-25L-PETROL-3-BEARING-CRANK-564394/114128689656?hash=item1a929999f8:g:LIgAAOSwHwReU~ll&redirect=mobile £85...

Could you not just buy a flywheel, housing and starter from a 3 mb and fit them as a set? Cheaper than £600.

A clear explanation thank you.

Its my understanding that trailers should be slightly 'nose down' so 100mm might be ok. I'd get the trailer then work out the technicalities later!

The rule of thumb is 'pins to power' Think of a domestic plug. The pin on your block 'should' (you can never discount PO bodgery) not be live. Have you a diesel or petrol model? White with a black trace is fuel stop solenoid on a diesel. The others (the white wires) should be switch live...

I'd start by checking/testing your ignition switch.

See here http://www.bilashakaflowers.com/LandroverSprings.htm

I don't think they will, I'll try and find a table containing all your spring options, stand by...

I haven't got round to modifying yet ( to much Christmas stuff getting in the way) . If you have your measurements to hand you can post them but don't go out of your way. Many Thanks.

Glad you're sorted.