N

neilc75

Active Member
My 2 speed ( fancy) series 3 wipers only work on 1 speed , very likely the brushes , a while back I bought a few sets of brushes for starter motor and ended up buying a new starter . I can see that the brushes are made of soft material , I don't see anywhere where you can literally buy the bushes seperately without the wiring , can I sand down the starter bushes and use those , from picture of bushes ava with wiring it looks as if they clamp into copper connectors , I'm originally from Yorkshire , if I can fix it for less , I'll have a go, I don't see any harm in it , if original bushes are low anyway , just wondered if anyone had tried this in the past .

Thanks.
 
Thanks both , Blackburn that one is actually the one I need , £10 +postage seems very good , however I'll probably still have a go at filing ones I have down , I have issues with replacing things if a good percentage can be salvaged , Im not quite sure why they don't just see the brushes , I'm sure I'll find out in the process , ill let you know , thanks .
 
Hope your not using an actual file. They can be expensive. Try finding a fallen stick and chewing a pattern in it. It’s much cheaper.
 
Yes you can file them but its fiddley - easy to crush in a vice, and messy, you get very black.
If you are really keen to recycle it is possible to break up a zinc/carbon D-cell and get the carbon electrode out then file that. I think its just too small for a wiper but it can be made to fit a dizzy cap.
 
Tried and failed , as mentioned the carbon brushes were just too brittle, also with the wiper motor they are basically square with ridges either side so they can slide , if you imagine they are like a chunky letter H , it was easy to file them down so that the dimensions were the same , however as soon as you start cutting those ridges they snap in half , still it's not cost me anything to have a go , I'll order the new ones , by the way , 1 of the brushes was missing hence only one speed and the others were really low .
 
Last edited:
We used to grind them down to size with the bench grinder if the need arose. They are only made from carbon.
 
You must log in or register to reply here.

Similar threads

S
starter motor questions
Replies
17
Views
2K
McBoon
McBoon
S
Lucas Starter Motor on Freelander 1
Replies
11
Views
675
Andy Warren
Andy Warren
IDK...
Series 3 can i put disc on it
Replies
12
Views
2K
Bobsticle
Bobsticle
jrose
Starter motor Brushes
Replies
8
Views
1K
Bobsticle
Bobsticle
Clive jones
Defender wiper motor replacement
Replies
2
Views
2K
dag019
dag019