Try adding power to the vin and ground to gnd - try pressing the control and see if you can hear the relay click

Looking at the other photos you've added, it may need power on he vcc+ and gnd to gnd....however there's also a IR sensor there, so where are you going to be putting this?

A better photo of the new part would help. Looks like it's switching a relay....so there really should be four connections... However, if there is only three it would suggest there's going to be a common earth, then power for the relay and then the power thats going to the compressor (or...

It confirms they're connected. Have you got a multimeter? Its the mode that usually beeps if you touch the two test probes together. If you don't have one, go and get one ;)

We'll see....the guy only had two for sale, however they were 1.5 m lengths, so I have three meters of repair pieces....I noticed quite a lot on ebay were 80cm pieces.... I'll try and do some photos at the same time

They were yrm pieces, got them on eBay, guy had bought them and then sold the landy......look fine, just need to get cutting and welding now.....likely a few weeks time though

Looks good. I'm picking up some repair pieces later today, so have this to do soon!

My back door (which I bought separately to the rest of the landy, so not a clue what year its from ) takes the same lock barrels as the rest of the doors. I bought a set off ebay and replace the front doors plus rear door. Quite interested that a kit is available of the ignition key that fits...

For what? Your gearbox or transfer box? If transfer box then it seems most are the same - Ashcroft Transmissions

99% sure that's the serialnumber of your transfer box, not gear box.

How is it you're doing it then? You're using your 1989 loom with the td5 dash? If so, you should be able to work out which cable did what on the old one, as the connector to lights is just metal running between the two (i think) - on the back of the 1989 dash. If you're doingit the...

:nopics:

I did a temp fix with bathroom sealent....fixed the problem, will take a look at other methods when I redo the roof at some point

I found the rear ones miles easier and quicker than front.

Maybe......what state is the other in? It could be worth replacing both, and then they're done. That way you'll need one of each

You need to take the grab handle and window winder off. I also take the door release and carefully take off the pop up lock thing then ease it off around the edge. Once you do that those fixings can be taken off and reattached

No.....in short. If you want two switches, they both need to be double pole

Couldn't you add a starter relay? Would mean less current travelling through your ignition, which should extend the life of it.

Pretty sure it's part of the chassis. Since you'd be welding it on, I'd imagine just a piece of metal with a hole would be sufficient? May be wrong, though....

I don't think you've said which year td5 bulkhead you've got. I've got one of the earlier ones (W reg maybe?) and the hazard switch does work (my original one broke, so before I ordered one I tried the one off my td5 bulkhead and it works. Wipers wise I'd use the TD5 one (even more so if...