attached a propshaft to the back axle spun it over and free'd off the sticking clutch!

Job for tomorrow.....fit fuel pump wire and fire up and move it about!!
 
Drove fae Catterick to Houston in Scotland (183 miles) the futherest i,ve drove the wee beast and she never missed a beat..........well apart from the pish aftermarket temp gauge going tits and reading 150 degress 5 mintues into the drive!

first job in january soundproffing the back as my god its noisey at 65 mile an hour!

oh and merry christams fur the morrow!
 
Last edited:
bigvinnie said:
Drove fae Catterick to Houston in Scotland (183 miles) the futherest i,ve drove the wee beast and see never missed a beat..........well apart from the pish aftermarket temp gauge going tits and reading 150 degress 5 mintues into the drive!

first job in january soundproffing the back as my god its noisey at 65 mile an hour!

oh and merry christams fur the morrow!
Click to expand...

try this stuff it's very very good.

CHEAPEST Horse Pony Stable Wall Mat Trailer Horsebox Easy Clean Foam Matting | eBay

1mtr will almost do both upper sides of a 110 hardtop. so to do sides and wheel boxes I'd get 4 mtrs
 
3.5 efi said:
what did you stick it with?
Click to expand...

Spray adhesive. try and get the Vehicle spray cos it resists high temps.

Also I did roof in 4 pieces fron centre down to gutter But with hind sight I wish I'd done it from gutter to first seam then seam to centre of roof And a thin strip overlapping where it joins the roof seam.

Will probably cut it to suit at some point.
 
Last edited:
Met up with tomtomtom and his very nice series. Then went for a tootle over to upton upon Severn. It's a bit wet there!

ImageUploadedByTapatalk1356374917.130823.jpg
ImageUploadedByTapatalk1356374926.892863.jpg
 
That's the river front. Without it the whole town would be 2 ft under. Drove through floods to get there. An x6 got turned away by coppers who saw me, smiled and said "have fun"!

Have noticed that all the older bridges locally at pershore, Worcester and Evesham are within 6inches of the tops of their arches. Some 8-12ft above normal. I think it the arches top out that's when it gets really bad.
 
Well I am about to have Christmas dinner then go and rescue scrappyloz who is stuck just outside Worcester.
ImageUploadedByTapatalk1356444416.861087.jpg

I ain't got a winch so if anyone local to Worcester has!!!!! Just off Worcester bypass at powick.
 
whilst christmas dinner was being cooked i ran some engine flush through the motor, new oil and filter plus tappet remedy ! and new front pads. Oh oh oh and i got a set of air tools for christmas, used them to get wheels off , makes life a doss haha :D
 
Finally got round to removing the lower half of the discos front bumper, the ****ty plastic bit ;) got to say Christmas lunch was a welcome break from rusted self taping screws and half of wiltshires mud falling into my hair ! :mad:
 
muddylightweight said:
Finally got round to removing the lower half of the discos front bumper, the ****ty plastic bit ;) got to say Christmas lunch was a welcome break from rusted self taping screws and half of wiltshires mud falling into my hair ! :mad:
Click to expand...

Consider yourself very lucky you've still got any!

It's a Land Rover. Stress alopecia will supervene in the normal course of events.
 
You must log in or register to reply here.

Similar threads

B
defender 2.4 puma reverse light switch
Replies
4
Views
375
BEASTIE 90
B
Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
410
Padda.116
Padda.116
Knappster
Shot-blasting steel wheels
Replies
9
Views
681
Knappster
Knappster
I
Re-coding of ABS Module after repacement
Replies
10
Views
729
invisible999
I
C
Freelander 1 crank no start
Replies
1
Views
1K
niccage
N