Will do, I've been looking over your challenge truck rebuild on Devon and got some ideas from that :) but no close ups of the front hoop mount so ill pay attention ;)
that was a nasty build, it needed a new chassis and the owner had stupid requests:eek:
 
Intercooler anyone ? :p
BCB1554F-88A4-4AAF-9D7E-01A1AD7E886D-165-0000000EB064BA5F.jpg
 
More progress with the roll cage mounts
E875C751-24A7-43A1-9B86-B296D7FADB9C-670-0000003FA1B3FCB4.jpg

5C579F67-B190-48B1-9B2E-B09535FCEFB2-670-0000003F8BA20DB3.jpg

5B0B3006-57F5-4825-9AA9-B9A2578126A4-670-0000003F806334E3.jpg


Gonna do some more supports from the chassis and some triangulation for strength :D
Overkill :D

Also cleaned out the inlet on the head as they were full of crap and made up some brake pipes :) more to come :)
 
Bit more ...
F18D6797-73E2-4E31-BD31-8EC81C99F884-1121-000000E266085E66.jpg

Wish I'd welded a plate across the crossmember first now but I don't think it's critical

Overkill is the way :D
 
The main hoop is finished :)
31016065-3930-4962-B445-4694B069B71B-1295-000000F2C492D76C.jpg

633CF098-970A-416D-AFA4-358F7FDADC56-1295-000000F2B42FA94C.jpg


How to make sure your cuts are straight ;)
6D246E87-CCC1-4054-ADEA-7C2E152CB389-1295-000000F314315A67.jpg

2D8CA247-A047-4C4F-9391-708DF7995E7E-1295-000000F320F8AC50.jpg


Brakes are finished and bled
019296A4-AA5E-48CB-9ED6-88840C0EF05B-1295-000000F303B94E5A.jpg


Bleeding machine applies pressure to the system pushing out air so all you have to do is crack off the bleed screws :)
89A916C3-4AE7-4096-84C2-9068614A6D24-1295-000000F2D5E625BF.jpg


Design for the front hoop mounts is sorted just gotta make it :rolleyes:
 
yes you should! its only as good as the weakest part!

After seeing your pic of the one you'd done on the tray back I realised, but it was too late by then :/ but I've got plenty of supporting plates to spread the load, and it's all made out of 10mm
 
Dam you and your workshop :p what did you use for your rad pipes? Is it stainless?

Hehe :) it's just standard thin walled mild steel at the moment, to make mountings, welding ect easier as we don't have a TIG, I'm not too worried about it being steel as isn't that what the block is made of ? ;)

Ill make one out of stainless eventually though :)
 

Similar threads