Fitted my flush mount LED reversing lights.

Screen Shot 2019-09-16 at 00.52.31.JPG

IMG_8841.JPG
IMG_8842.JPG
 
Last edited:
Been Sailing! right through my MOT no Advisories and emissions of 0.68 K(1/m) /Smoke temp Min 22 max 25

Not bad for 116K TD5
That's great news, well done. Wish I could get my emission down that low, injectors are my next focus.
 
That's great news, well done. Wish I could get my emission down that low, injectors are my next focus.
Engine oil change every 6 to 8K, 30 min run before MOT.
Been using this for 15 years, we have 5 diesel engines including a generator, its use in all.

Screen Shot 2019-09-23 at 22.32.01.JPG
 
Ordered some.
Mine looked fine in cylinders 2, 3, 4 but 1 and 5 were very sooty, thinking of sending those injectors to be tested.

wait till 1/4 in tank, give it third of bottle, blat along steady at 50 for around 30/40 mins do this a few times and you will see a difference
 
Ever decided to do one job and then suffered from the 'might as well do the XXX while i'm there" AKA Triggers Broom syndrome?
What started as swivels is now,swiv housing, stub axles, wheel bearings, shields, CV, etc entire hubs ends on both sides, then season with Timkens and Corteco all round of course.

Stonechipped the brake mud shields etc.

And why the fook not eh?:cool:

IMG_9820.JPG
IMG_9821.JPG
 
Last edited:
Front Swivels, Stub Axle's CV's, Drive Shafts, Wheel Bearings the usual from end refurb...only been putting it off since Nov, as I have been building a music / rehearsal studio at home.

So grabbed some cider, flicked on the A Team sound track and went at it.......


IMG_1910.JPG
IMG_1960.JPG
IMG_1964.JPG
IMG_1965.JPG


IMG_1862.JPG
IMG_1863.JPG
IMG_1864.JPG
IMG_1865.JPG
IMG_1869.JPG
IMG_1871.JPG
IMG_1872.JPG
IMG_1873.JPG
IMG_1877.JPG
IMG_1879.JPG
IMG_1880.JPG
IMG_1881.JPG
IMG_1885.JPG
 
Last edited:
LH DRIVESHAT!
I may.....just may mind..... have been a bit teeny weeny bit heavy handed when gently teasing / tapping it out ( with a club hammer, red face and a bit of colourful language)

Just as well I have a new HD one...:rolleyes:

IMG_1887.JPG
IMG_1889.JPG
IMG_1890.JPG
 
Chopped up old Swivel to make a bench mount. Its V tough and about 5-8mm thick, but so much better making up new one on the bench
IMG_1899.JPG
 
Last edited:

Similar threads