G

ggp

New Member
has anyone got a hayens manual for the 200 series as i need a fual pump diagram so i can find this fual cutoff solinoid i think this is probally my problem as i had a couple of non starting episiods now she just wont stop. and can u clean this thing or dose it have to be changed
 
I do everything on the cheap and tried to clean it. There might be some metal filings (i.e. bits of your fuel pump) in there. I had a200tdi in a defender and the stop solonoid was near the lift pump (on the drivers side). It turned out mine just needed a new spring.

Before you take it out try leaving the engine running, turn off the ignition and then tap the solonoid with a small hammer.
 
its on the injection pump towards the rear on the top. 24mm spanner with really thin sides, a right bastard to get off, i ground the sides down on a normal spanner to make it fit, be careful whenm you remove the solenoid there is a little black plastic bit that falls off into the housing ;)
 
i think the ip is in the same place, its just a few of the ancillaries that are
different
 
dont know what i did but when itried today she ran and stoped as normal hopefully this wont be areocuring fualt but at least it saved 60 odd qwid (for now at least) thanks for all your advise
 
One spanner, one wire, how difficult can that be?

Even a GIRL could manage this job.

Well ...... maybe not .........

CharlesY
 
You must log in or register to reply here.

Similar threads

C
3.9 efi no fuel, wont start, tested injectors right bank 8 ohms.........
Replies
7
Views
2K
cljcars
C
S
2012 Disco 4 Just wont start.
2
Replies
26
Views
4K
Stanleysteamer
Stanleysteamer
styleruk
2.25 petrol rough idle
Replies
16
Views
796
styleruk
styleruk
JokerUK
Sport MAP/MAPT Sensors on 4.2 S/C
Replies
0
Views
761
JokerUK
JokerUK
xDParis64
Hello Again! (SOLVED, Engine replacement)
2 3
Replies
56
Views
3K
xDParis64
xDParis64