Chema Disco v8
Member
,
Chema Disco v8
Member
No I cannot open them
sierrafery
Well-Known Member
So you pull the handles inside on all doors and nothing happens after two consecutive remote unlock commands while you can open the driver's door only?
Chema Disco v8
Member
I press the remote, twice and the system works (like in you the receiver gets the signal and try to unlock) but none of the door locks open. I still need to use the actual key to get inside the car.
sierrafery
Well-Known Member
I understood the unlocking thing, answer exactly to my question if you want help
Chema Disco v8
Member
Yeah nothing happens
sierrafery
Well-Known Member
So all the doors except the driver's are stuck closed no matter what you do boot included?
Chema Disco v8
Member
Yes
sierrafery
Well-Known Member
Then you have a serious problem as they are all superlocked which means something happned on that particular circuit... a nanocom or similar is needed to try to force the superlock motors unless it's a BCU or wiring issue... on a scale from 1 to 10 where are you when it's about understanding circuit diagrams and electrical troubleshooting? you must be above 8 to understand what to do based on my instructions or you need a skilled auto electrician who knows D2s
Chema Disco v8
Member
Damn, I am good with circuits, and following instructions can be done for sure. Would it be a good call to try to use a nanocom before going any deeper into the electricals?
sierrafery
Well-Known Member
The best would be to try with nanocom body outputs from BCU to force the superlock first to rule out the BCU before chasing other issues... you can try a trick but you'll have to do somehow to remove one door card from any door other than the driver's as to reach the actuator's connector, if you can do that i'll tell you what to do next
Last edited:
sierrafery
Well-Known Member
Actually it might work from the driver's door too if you are lucky but that's not 100% sure... so remove the driver's door card, unplug the actuator and splice with two wires into the pink/grey and pink/purple wires from pins 6 -7(attached) as to be able to feed those wires from outside, connect back the actuator and give earth and +12V to those wires for a second one way then unlock with remote, if nothing happens revert polarity and unlock again with remote... be aware, the extra wires must not be connected to anything while you unlock with the remote you must feed them for a second then let them in the air for remote command if you see what i mean ... do that and report the result, let the door card off for further tests if needed
Attachments
Chema Disco v8
Member
Ok I will try that
Chema Disco v8
Member
Ok, i have a couple of doubts before i proceed. When u mean the extra wires cannot be connected to anything… should i pull all of them out of the actuator or need to cut them all and join after the procedure.
What would u use to give the 12v and esrth to the cables?
sierrafery
Well-Known Member
I dont understand your doubts, i can't explain better than i already did, i said "splice into" which means use posi-taps or skotchlocks or something into the wires as they are, it's nothing about pulling or cutting anything and you can take +12V from the fusebox and earth from any metalic part there.... if you have doubts after you read again carefully what i wrote and it's not clear means that my english is not good enough or you better not play with electrics
