M

mike07986

New Member
hello all my p38 is having abs issues I had a fault for the osr sensor I checked it with a multimeter and it had no output so replaced it it now has a output and on the computer the readings are all within spec but it bings up a fault with osr sensor output to low has anyone had this issue iv searched and searched and still haven't had any luck many thanks mike
 
Didn't know you could check them with a meter!!

Live and learn but hall sensor aren't my bag!
 
mike07986 said:
hello all my p38 is having abs issues I had a fault for the osr sensor I checked it with a multimeter and it had no output so replaced it it now has a output and on the computer the readings are all within spec but it bings up a fault with osr sensor output to low has anyone had this issue iv searched and searched and still haven't had any luck many thanks mike
Click to expand...

Have you cleared the stored fault?
 
Saint.V8 said:
Didn't know you could check them with a meter!!

Live and learn but hall sensor aren't my bag!
Click to expand...

They are magnetic if you put a multimeter on them then wave metal across the tip you will get a change in reading. However to get the sensor to work on the system it needs a 5 volt feed from the ECU.
 
iv cleared the fault every time it appears with autologic comp I checked the volts to it before I changed the sensor and I had 5.02 both sides thanks mike
 
mike07986 said:
iv cleared the fault every time it appears with autologic comp I checked the volts to it before I changed the sensor and I had 5.02 both sides thanks mike
Click to expand...

Did you push the sensor in until it was touching the reluctor ring?
 
both it comes up abs fault and traction failure on start up I drive down the road sometimes it bings up with out me braking etc then other times it bings up if I brake hard
 
Hi, yes i have a similar problem, spurious t/c abs lights. not got to the bottom of the problem yet/
 
yes it was a cheap sensor from ebay I think il swap it side to side and see if it changes the fault to the other side
 
Having just had abs tc errors on my p38 5 mins after just passing its mot, lights and tc came on replaced the accumulator no difference, was 2 dud sensors from ebay only new last year..

Found out they were at fault with a multimeter set to ohms and the sensors still in place un pluged each one to look for a solid reading, back ones where .900 each front ones ebay ones were up and down and in 1.2 then down to .03 and such. Ordered 2 news ones tested on meter before fitting both fixed reading at .900 flat fitted them and abs tc been off since

Hope this can help a little
 
You must log in or register to reply here.

Similar threads

A
P38A Cruise control question ( wheel speed issue )
Replies
16
Views
823
AndyF07
A
O
03 L322 EAS ECU Can bus fault / ABS temp system deactivation
Replies
1
Views
277
oldradiotech
O
B
ABS Issue
Replies
14
Views
607
Bangerang1
B
kricktd5
L332 abs/ HDC
Replies
1
Views
726
Datatek
Datatek
I
L322 ABS query
Replies
0
Views
808
isamyku
I