F

fiatpandaman

Member

• Jan 14, 2019

• #21

Thanks all, I'm going to drag it up to my dry unit and start the task of drying everything and cleaning everything, Always amazed at this place and the people (thanks esp Mozz + Datatek) Ill keep everyone updated. Hopefully resolve with out needing to replace the BECM. I needed to fix the heated seat any way so its a good excuse.

 

kermit_rr

Very

Full Member

• Jan 14, 2019

• #22

A simple thought, if you have unplugged the rf antenna in the bit then it won't sync when you put the key in the ignition. I have to plug mine back in when i need to resync. Then unplug again after

 

Datatek

Well-Known Member

• Jan 15, 2019

• #23

fiatpandaman said:

Thanks all, I'm going to drag it up to my dry unit and start the task of drying everything and cleaning everything, Always amazed at this place and the people (thanks esp Mozz + Datatek) Ill keep everyone updated. Hopefully resolve with out needing to replace the BECM. I needed to fix the heated seat any way so its a good excuse.

Click to expand...

If the BECM has failed, Rick the Pick is your man, he can fix them.

 

F

fiatpandaman

Member

• Jan 15, 2019

• #24

Good morning all,
I removed the carpet last night and left the heater fan on, 3 hours later after re-plugging in the battery its started.
This is good news as it means I can now drive it to the unit and dry it out properly rather than on my driveway. I would have been lost without all the help from you all, so thanks

 

Datatek

Well-Known Member

• Jan 15, 2019

• #25

fiatpandaman said:

Good morning all,
I removed the carpet last night and left the heater fan on, 3 hours later after re-plugging in the battery its started.
This is good news as it means I can now drive it to the unit and dry it out properly rather than on my driveway. I would have been lost without all the help from you all, so thanks

Click to expand...

Good news indeed. Remember to leave the aircon on at all times to help keep the electronics dry

 

mozz smith

Well-Known Member

• Jan 15, 2019

• #26

well done Sam , keep up the good work , ok mate u know where we are if you need further help , kind regards Mozz

 

M

Mukiwa

Well-Known Member

• Jan 22, 2019

• #27

I'm not too far away - depending on which bit of Shropshire you are in and I have a Nano fiatman if you need to use one. However I'm not an expert with it but do know enough to be dangerous