Thanks all, I'm going to drag it up to my dry unit and start the task of drying everything and cleaning everything, Always amazed at this place and the people (thanks esp Mozz + Datatek) Ill keep everyone updated. Hopefully resolve with out needing to replace the BECM. I needed to fix the heated seat any way so its a good excuse.
 
A simple thought, if you have unplugged the rf antenna in the bit then it won't sync when you put the key in the ignition. I have to plug mine back in when i need to resync. Then unplug again after
 
Thanks all, I'm going to drag it up to my dry unit and start the task of drying everything and cleaning everything, Always amazed at this place and the people (thanks esp Mozz + Datatek) Ill keep everyone updated. Hopefully resolve with out needing to replace the BECM. I needed to fix the heated seat any way so its a good excuse.
If the BECM has failed, Rick the Pick is your man, he can fix them.
 
Good morning all,
I removed the carpet last night and left the heater fan on, 3 hours later after re-plugging in the battery its started.
This is good news as it means I can now drive it to the unit and dry it out properly rather than on my driveway. I would have been lost without all the help from you all, so thanks :)
 
Good morning all,
I removed the carpet last night and left the heater fan on, 3 hours later after re-plugging in the battery its started.
This is good news as it means I can now drive it to the unit and dry it out properly rather than on my driveway. I would have been lost without all the help from you all, so thanks :)
Good news indeed. Remember to leave the aircon on at all times to help keep the electronics dry:D
 
I'm not too far away - depending on which bit of Shropshire you are in and I have a Nano fiatman if you need to use one. However I'm not an expert with it but do know enough to be dangerous :D
 

Similar threads