Where's the barf mojees when you needs one..






Oh! Here it is! :vb-crazy::vb-crazy::vb-crazy::vb-crazy::vb-crazy::vb-crazy::vb-crazy::vb-crazy::vb-crazy::vb-crazy::vb-crazy:
IMG_3036.png
 
Houston............. We have a problem! (No surprises there really). :)
I tried putting all the half-shafts, backplates and the 2WD unit in place as it will be in the final configuration on the "Delta Trike".
Serious "binding" issues and on one side the half shaft just would not insert (despite the use of a very large "persuader").
It looks like something is scoring a line along the half-shaft as it is slid/pushed/hammered inwards.
It only takes the tinies bit of misalignment to totally kybosh it all it seems. :(
I found that despite almost getting there when the hub-shell reached the shoes it stopped totally.
This is a concentricity failure I think, so I will have to find out what has introduced it.
It may be as simple as a shim/washer to take a twist out of a backplate (I hope).

It does call into question the viability of the design because I would hate to try and pull these half-shafts out without a whole mess of tools around to attempt it.
Doing it at the roadside would be a nightmare I think. :(

Oh well, a lofty enterprise is still a good learning opportunity even if the outcome is not as one had hoped. We shall see, tomorrow is another day. :D
Well can't be bad if that's the only shaft situation in the household
 
Couple of things happened today........firstly I was looking for a mixing stick for 2 pac paint my mate hands me his new alloy
ruler said just use that I said its new, aye its ok so I mixed the paint with hardener & added sand for grip cause its deck paint
any hoo I mixed it up then wiped the rule & all the markings came off it 🤣 🤣 I just burst out laughing & handed it back
to him haha his face was a picture 🤣
 
Couple of things happened today........firstly I was looking for a mixing stick for 2 pac paint my mate hands me his new alloy
ruler said just use that I said its new, aye its ok so I mixed the paint with hardener & added sand for grip cause its deck paint
any hoo I mixed it up then wiped the rule & all the markings came off it 🤣 🤣 I just burst out laughing & handed it back
to him haha his face was a picture 🤣
I did the same with IPA on my sewing ruler once 🤣
 
Guid morn
It's now the Monsoon season in this part of the world. It's absolutely chucking it down.
So getting dragged around shopping centres. Apparently the one we are in is the largest in Korea, so that's the next 5 hours accounted for... Where's the coffee shop !
 

Similar threads