Hello all,
Back on this matter.
Bought a nanocom evolution. Erased all EDC errors and problem reappears.
Errors logged this morning were:
NANOCOM - EDC.APP - EDC faults file
GLOW PLUG (HEATERS) FAULT
Type: INVALID FAULT,LOGGED,INTERMITTENT
RPM = 42
WATER TEMP = 117
OCCURRANCE = 3
---
ENGINE SPEED SENSOR INVALID VALUE
Type: INVALID FAULT,MAJOR FAULT,LOGGED,INTERMITTENT
RPM = 0
WATER TEMP = 88
OCCURRANCE = 11
This fault pops up from time to time when cranking the engine.
---
ENGINE IMMOBILISER LINK FAULT
Type: TOO LOW,LOGGED,INTERMITTENT
RPM = 0
WATER TEMP = 175
OCCURRANCE = 6
---
The glow plugs were all taken out and tested last week. Before that I tested them with a multimeter. To me, visually, they are fine.
How can engine immobiliser have an intermittent fault?
Iv'e checked the connector under the fusebox and it seems ok.
Should I look for the data link wires used for immobiliser?
Regards