Dover mike · Jun 30, 2023

very nice work mate

--ped-- · Jun 30, 2023

looks good

UpandOver · Jul 1, 2023

Progress report……. Today I have been mostly cleanin the rust off pedal boxes…… then spraying them black….. oh an made a new brake pipe …… and havin a few beers…..

--ped-- · Jul 2, 2023

that's what i'm on with today,i did buy premade ones but th lengths on some were out so i decided to run full length braided hoses

UpandOver · Jul 3, 2023

--ped-- said:
that's what i'm on with today,i did buy premade ones but th lengths on some were out so i decided to run full length braided hoses

Must have been the same supplier as my lines as I had to make three new ones as they were not the right lengths

UpandOver · Jul 3, 2023

Both brake and clutch boxes rebuilt, brake lines made, fitted and bled.

miktdish · Jul 3, 2023

Looking at your pics I feel the urge to take the wings off my Fokker and give it a good clean .... :vb-head-over-heels:

UpandOver · Jul 6, 2023

New fuel tank installed , fuel pipes clipped to chassis. Wiring looms re taped and installed

UpandOver · Jul 6, 2023

Inner wings back from galv and looking like new

UpandOver · Jul 9, 2023

Not that much to report really as I’ve been away over the weekend, but having got home this afternoon I couldn’t keep out of the garage.
So handbrake shoes and drum fitted along with the new rear prop shaft and handbrake cable.

UpandOver · Jul 9, 2023

New one piece braided clutch pipe fitted and bled, I know its not the standard setup but some improvements are required. Plus I co@&ed up and scrapped the old pipes which would have cost £65 just to replace the top steel pipe then another £20 for the flexi hose and steel lower pipe. BRT Motorsport £38 delivered for one Quality piece of braided hose…. Job done!

UpandOver · Jul 9, 2023

New oil cooler hoses loosley fitted.

UpandOver · Jul 9, 2023

Cant wait to get this landy finished if only to stop ordering parts …. I’m starting to worry that Simon the DPD driver is seeing more of my wife than I am ….

UpandOver · Jul 10, 2023

Steering shaft cleaned painted with new UJs, throttle pedal blasted and painted and fitted with stainless fasteners.

UpandOver · Jul 24, 2023

Apologies for the lack of progress but after another trip on the motorbike to Ireland then a second trip to MedVac a fallen comrade I’m back in my first home (as the wife calls it)

UpandOver · Jul 24, 2023

Lower dash cleaned, painted and the outside polished with black wax which to be honest transformed it. Just make sure you wear some latex gloves when your using this stuff.

UpandOver · Jul 24, 2023

Vent flaps fitted with some stainless steel hindge pins / bolts from SP4x4. Plastered them in ceramic grease first and thread locked the tiny m4 dome nuts each side, there would be nothing worse than a loose flap now would there !

UpandOver · Jul 24, 2023

Galvanised side rails fitted with some stainless bolts, no rust to be seen here sir!

Knappster · Jul 24, 2023

Looking good!

UpandOver · Aug 1, 2023

Dash nearly there I’ve ordered a new genuine td5 ignition along with three door barrels will have to change the door handles for the deeper lock td5 ones as well but at least all the locks will be the same.

Member

Active Member

Well-Known Member

Active Member

Well-Known Member

Well-Known Member

Attachments

Guns n Chainsaws

Well-Known Member

Attachments

Well-Known Member

Attachments

Well-Known Member

Attachments

Well-Known Member

Attachments

Well-Known Member

Attachments

Well-Known Member

Well-Known Member

Attachments

Well-Known Member

Well-Known Member

Attachments

Well-Known Member

Attachments

Well-Known Member

Attachments

Well-Known Member

Well-Known Member

Attachments

Similar threads