I do have a very rare spare set of shells, should I try them before anything else or do some measuring first? This is a pain lol
 
yeah looking at the shells it was rubbing on the edge of a couple but then when I saw the much more rubbing in the middle of the majority it was less of a worry lol
 
fett said:
yeah looking at the shells it was rubbing on the edge of a couple but then when I saw the much more rubbing in the middle of the majority it was less of a worry lol
Click to expand...

if block was twisted youd expect contact marks to represent that
 
bugger, well you have seen the pics mate- does it seem that way?

will align boring fix that?
 
Ok, so put all the caps back on and torqued to the insane 110ftlbs that ARP recommend and then had a measure with a vernier, the v is for vertical and the H is horizontal but really it was more diagonal as I couldnt really get the verniers in there very well.All measurements in mm.

v / H
69 / 68.95
68.96 / 68.84
68.96 / 68.94
69.03 / 68.88
69.01 / 68.88


What do you think?
 
Last edited:
actually no, thing is those studs only work at 110, 55 would be way too loose for them to work according to r/s

what would you think, align bore?
 
v / H
69 / 68.95 2 thou
68.96 / 68.84 over 4 thou
68.96 / 68.94 less than 1 thou
69.03 / 68.88 2 thou
69.01 / 68.88 over 1 thou
 
fett said:
actually no, thing is those studs only work at 110, 55 would be way too loose for them to work according to r/s

what would you think, align bore?
Click to expand...

cant see that those bolts are much better than std ,they are only as strong as block threads ,hard to say 1 or 2 thou can be expected but as you mentioned not accurately meaured, the point about checking at std torque was to see if extra torque caused distortion
 
I gathered that mate, too late now though as they are loctited in with high strength/temp loctite as per instructions. TBH I would go for the stander bolts if I had a do over.

Mark thanks for the conversion, so thats 4 thou out on one, Id better see if thats the worse one!

Who does align boring then? it would fix this right?
 
fett said:
I gathered that mate, too late now though as they are loctited in with high strength/temp loctite as per instructions. TBH I would go for the stander bolts if I had a do over.

Mark thanks for the conversion, so thats 4 thou out on one, Id better see if thats the worse one!

Who does align boring then? it would fix this right?
Click to expand...

your not at line boring yet ,marks on shells didnt show a pattern to me ,4 thou isnt good but is it correct
 
so why is it so tight? hmmm glad I am not at align boring yet as not cheap lol

come on master tech solve it :D :p
 
You must log in or register to reply here.

Similar threads

PopPops
Disco 2 Crank speed high
Replies
5
Views
262
mad85
mad85
J
Can you advise me on l322 M62 BMW 4.4 Vanos?
Replies
2
Views
383
biketeacherdave
biketeacherdave
styleruk
2.25 petrol rough idle
2 3 4
Replies
60
Views
2K
styleruk
styleruk
B
Self tappers!
Replies
3
Views
330
dag019
dag019
A
Engine cutting out 2.25 petrol
Replies
3
Views
1K
Tony Monsantoe
Tony Monsantoe