Good morning.
My nanocom says "no faults found" in WABCO page. Even so, I clear faults. The only other faults, anywhere are in the MOTRONIC page, P0175 mixture adapt. P1592 rough road. both no longer present and can be cleared.
All corners have had hubs/bearings, oil seals, CV joints, abs sensors. I've renewed the abs accumulator and pressure switchalso both brake switches. Double bled the braking system as per gospel. The abs pump kicks in on the fourth pedal depress, sometimes five.
My problem started with occasional appearance of the abs and tc lamps only on slow manouvres. e.g. Parking/reversing/back-forth. Re starting cleared them off each time.I could do thousands of miles in between. Now, the abs blink produces "traction control fail" on the dash with the abs tc lamps remaining on. I get the "traction fail" on switching off. In addition, "abs fault" flashes up mometarily after a short number of metres never to be seen again. I get identical resistance readings both at the sensor and ecu end of the loom. I've contacted blackbox who say if nanocom says no faults and ECU settings can be read then, there are no faults and the ecu is likely to be ok. I've renewed the relevant relays and checked fuses.
Knowing me, the obvious or stupidity can't be ruled out.
As ever, any help would be appreciated. best regards. P
My nanocom says "no faults found" in WABCO page. Even so, I clear faults. The only other faults, anywhere are in the MOTRONIC page, P0175 mixture adapt. P1592 rough road. both no longer present and can be cleared.
All corners have had hubs/bearings, oil seals, CV joints, abs sensors. I've renewed the abs accumulator and pressure switchalso both brake switches. Double bled the braking system as per gospel. The abs pump kicks in on the fourth pedal depress, sometimes five.
My problem started with occasional appearance of the abs and tc lamps only on slow manouvres. e.g. Parking/reversing/back-forth. Re starting cleared them off each time.I could do thousands of miles in between. Now, the abs blink produces "traction control fail" on the dash with the abs tc lamps remaining on. I get the "traction fail" on switching off. In addition, "abs fault" flashes up mometarily after a short number of metres never to be seen again. I get identical resistance readings both at the sensor and ecu end of the loom. I've contacted blackbox who say if nanocom says no faults and ECU settings can be read then, there are no faults and the ecu is likely to be ok. I've renewed the relevant relays and checked fuses.
Knowing me, the obvious or stupidity can't be ruled out.
As ever, any help would be appreciated. best regards. P
Last edited:
