bustersbus
Well-Known Member
- Posts
- 13,755
- Location
- Near Dumfries, Scotland
Reverse light switch renewal
This is how ah did mine....
Firstly remove the middle seat and lift the lid to expose the top of the gear box. You should then see the switch. Undo the two wires and then loosen the lockin' nut.....
then just unscrew the old/faulty switch.
this is all ah used to do the job.. 17mm & 14mm spanner, a piece of wire with two blade connectors to see if it was a fault in the wiring, and the new switch...
this is just a pic of the old and new switches...
Then ah stuck it into reverse gear and screwed in the new switch. Ah put a big mirror rested against the wheelie bin so's ah could see when the light come on, then tightened the lockin' nut.......
That's it, job done
This is how ah did mine....
Firstly remove the middle seat and lift the lid to expose the top of the gear box. You should then see the switch. Undo the two wires and then loosen the lockin' nut.....
then just unscrew the old/faulty switch.
this is all ah used to do the job.. 17mm & 14mm spanner, a piece of wire with two blade connectors to see if it was a fault in the wiring, and the new switch...
this is just a pic of the old and new switches...
Then ah stuck it into reverse gear and screwed in the new switch. Ah put a big mirror rested against the wheelie bin so's ah could see when the light come on, then tightened the lockin' nut.......
That's it, job done
