bustersbus
Well-Known Member
- Posts
- 13,755
- Location
- Near Dumfries, Scotland
Removing door hinges from the bulkhead.
Heres how Ah did it ..
To remove the hinge from the bulkhead Ah used an impact driver to get the bolts out
To see this
Usin a thinnish screwdriver ah stuck it in the captive nuts and lifted them out
Ah threw the old ones away and replaced with some shiny new ones
Then its just a case of stickin the new ones in usin the screwdriver again to get them on
Once the captive nuts were fitted, it was just a case of stickin some copper grease on the bolts and stickin the hinge back on with the gasket.
A wee tip do the top hinge first because if the captive nuts fall in its easier to get them out from the bottom hole usin a long screwdriver and magnet.
Thats it, job done
Heres how Ah did it ..
To remove the hinge from the bulkhead Ah used an impact driver to get the bolts out
To see this
Usin a thinnish screwdriver ah stuck it in the captive nuts and lifted them out
Ah threw the old ones away and replaced with some shiny new ones
Then its just a case of stickin the new ones in usin the screwdriver again to get them on
Once the captive nuts were fitted, it was just a case of stickin some copper grease on the bolts and stickin the hinge back on with the gasket.
A wee tip do the top hinge first because if the captive nuts fall in its easier to get them out from the bottom hole usin a long screwdriver and magnet.
Thats it, job done
