Latest activity

Okay please explain how it routes to the brake caliper????? Thank you for your help

2019?

I got a reconditioned one (exchange) for £145 a few years back. Worked fine. 4 hours labour to have it fitted.

Rtfm

They lied

You int lived old boy Nivver too late. .

Code reader needed.

Does it lower overnight? Compressor should be pretty quiet and certainly not audible from the drivers seat. @gstuart will offer much more advice than me.

2009 freelander 2 steering rack How much you reckon for a new one please

To read modulation the engine has to be running at max temp. You're looking for 50% for perfection but a bit either side of that doesn't make any real differance.

Hi Everyone, Discovery 3 air suspension question if I may: The suspension actually works but does have a few issues that I would like some advice on please. When moving up and down I hear a loud compressor noise for quite a while once fully...

What a shame!

Hi Everyone, I have just aquired my first ever Discovery, not really ever had a 4x4 that I've actually driven. I have just purchased a 2005 Discovery 3 SE 2.7 TDV6 auto. (for the family wagon) There is a problem with the electronic handbrake...

are we talking about the ball on the throttle activator being in the slide on the pump shaft if it not in the probability is that it will not run and also if the top housing is to far fowaed it wont run has this pump run at all? are you getting...

And if you want the correct gear knob for a 2a it has a flat top unlike the round series 3 one in photo. Available from John Craddock Land rover parts.

No I do not, but try John Craddock

No, only me so have to rely on what they say. Trying to get a mechanic is hard work, always booked up for weeks and a lot don't work on Land Rovers. Thank you for replying

I have bought this one: will that be enough?

And had a bit of usage ;)

Nowt worse than sticky flaps:rolleyes::rolleyes: ;)

Sorry, I'm panicking a little. Yes, I followed the prompts and had the battery charger connected, but something went very wrong—I think my battery might be dead because the voltage dropped too low. I already ordered a new battery and a proper...

You'll need a compressor to seat the bag on the seals when you put it back on, takes about 40-50psi I think. Probably good to have a lovely assistant around to hold the strut up while you pull the bag down at the base and inflate it a bit too...

Where did you get the seats? I'm fairly certain we have those exact seats, but on office chairs at work. :D

Necroing my own thread. Both CV Axles have been replaced and my shudder is now only due to a slight alignment error, which is getting fixed(tire shop wouldn't do it due to a rusted stuck steering linkage). Seals replaced and only leakage is from...

Ah well in that case it is angle grinder and flap disc to remove the last of the evidence, some black chassis wax and present for mot at another place.

I'm in big trouble o_O can someone help me recover (maybe remotly) from bad configuration update?

Apparently who ever cut it off had left a part of it still attached

How would they even know it had them as std?

Yeah the bags look pretty good to be honest, no that old at all in person. I think I’ll get the shock out and give it a proper going over, might give the new O-rings a try, will see. Thanks for all the help.

Although I am just guessing here, you may find that if it wasn't in the earlier brochure it was available through the special vehicle branch, which was far more of a bespoke rather than a package type specification. For example the utility...