zenith carb slop

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
L

Landyfella

Active Member
Posts
162
Location
Cambridge

Attachments

  • butterfly.jpg
    butterfly.jpg
    156.7 KB · Views: 96
Last edited:
I got a refurb kit from zenith for mine A few years back and it comes with new butterfly (As well as jets etc) and when stripped and cleaned the housing it worked a treat. Not too pricey either I seem to remember. Can’t say anything about Entire replacement though
 
Thx for the message. Yeah I got a refurb kit, it was more a question of the slop where the bar rubs against the housing and wears over time. Do you drill it out and put a bush in?
 
Even if it is allowing a bit of extra air into the throat, I don't think it will be enough to make any difference, you could always have a look at the spark plug electrodes to see what colour they are. That's how I judge the fuel/air ration.

Col
 
Mine stil has a bit of play - not as much as yours but I just left it. If you could find the right size Bush then guess there’s no harm fitting it but I’d be tempted to refurb and check the mixture works ok before bothering.
 
If you do attempt a bush job do not attempt to drill it, the drill will follow the worn hole and produce an oval hole. It will need setting up on a milling machine and boring with a slot drill (2 flute milling cutter). Make the bush on the lathe from aluminium/bronze or brass, all of these materials will outlast your time with the Land Rover.
 
You must log in or register to reply here.

Similar threads

L
Diff front oil seal replacement
Replies
10
Views
1K
Landyfella
L
Blob
L322 Solved - C1A13-64 (AF) Pressure does not decrease when venting gallery
Replies
2
Views
3K
stuu
stuu
S
Defenders Vs Insurers tomfoolery
Replies
1
Views
3K
lightning
lightning
MonceHys
Rodent Attack
Replies
7
Views
963
norseman
norseman
Blob
L322 Let's have your technical opinions then. Coolant leak and cracked manifold?
2
Replies
24
Views
4K
Blob
Blob
Back
Top