- Posts
- 351
- Location
- Poole Dorset
Hi folks,
As the header says ..why only one? Does it fit the petrol tank side?
any ideas. Cats
As the header says ..why only one? Does it fit the petrol tank side?
any ideas. Cats
Why only one bolt plate? mrc5509
- Thread starter catman275
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 351
- Location
- Poole Dorset
tottot
Well-Known Member
- Posts
- 8,028
- Location
- west wales coast
It is something of a special bolt with rubber washer that allows a tad of movement. Think it is to do as allowance for different expansion rates of tank full of juice and chassis as temp changes. Probably would not matter in UK but in the Sahara desert cooking by day and freezing at night, prevent stress cracking of tank mounts.
Last edited:
Anaconda
Well-Known Member
- Posts
- 3,556
- Location
- Thames Valley
It has a (2) in the diagram, would that suggest there should be two?
I'm not much use as I don't even know where it goes.
I'm not much use as I don't even know where it goes.
tottot
Well-Known Member
- Posts
- 8,028
- Location
- west wales coast
There are 3 bolts in rear bracket and just the one on the front.
steve2286w
Well-Known Member
- Posts
- 4,523
- Location
- monkeyangerland
2. Means metric thread
David Leech
Well-Known Member
- Posts
- 302
- Location
- Galway, Ireland
It goes at the back of the "drivers outside seat rail". You won't be able to get a spanner underneath 'cause of the tank.....
David Leech
Well-Known Member
- Posts
- 302
- Location
- Galway, Ireland
