Salisbury Nick
Well-Known Member
- Posts
- 790
- Location
- Dorchester
Wheel well in boot filling with water - P38
- Thread starter Salisbury Nick
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 58,170
- Location
- Preston Lancs.
Used to be contained in the up to 1999 version of RAVE. But i now have the later version and it is not in that. If you want to look for it is. Bulletin 0011 L8403bu Issue 1, date 18-03-98.
Last edited:
Salisbury Nick
Well-Known Member
- Posts
- 790
- Location
- Dorchester
Thanks Wammers, I just took yours and Datateks advice. Took the existing seal off and gave the flange and area a really good clean out.
Bent the flange out where the bend is between the lower and upper sections and then replaced the seal with some grease around the bend too.
Fingers crossed now. I suspect I won't need to wait long to see if it fixes it or not!
Bent the flange out where the bend is between the lower and upper sections and then replaced the seal with some grease around the bend too.
Fingers crossed now. I suspect I won't need to wait long to see if it fixes it or not!
Datatek
Well-Known Member
- Posts
- 45,018
- Location
- Near Poitiers SW France
You may need to do the top corners too, I did on mine.
