Wheel/tyre question
- Thread starter Mick X11
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
GrumpyGel
Well-Known Member
- Posts
- 26,397
- Location
- Christchurch, New Zealand
Very much doubt it. The Range Rover is a Ford Mondeo not a Rover/Honda. They'd probably fit an F2 but not an F1.
pardec
Active Member
- Posts
- 993
- Location
- South Manchester- North Devon
NO
Last edited:
andyfreelandy
Well-Known Member
- Posts
- 5,563
- Location
- Devon
'Copper tyres' !! Sounds like Boadicea's chariot !
Are they off an FL1 Nodge? My FL1 HSE has 17s as standard as I'm sure you know, all 5 need refurbishing, 2 of them being nasty, rather than waste a load of cash having them done I was looking on ebay and found a nice set of refurbed 18" evoke wheels in black, hence my original question. I'm not fussy if they are 17" or 18", I was trying to stay with land rover rather than horrendously expensive aftermarket ones!
Yes. They're Freelander 1 Facelift Sport rims. They are the only factory 18" rims that fit the FL1. They are difficult to find though, and very expensive as a result.
I know. I have a set of 5 HSE rims myself, which I use if I'm going off road, rather than mess up my lovely Sport rims.
All later LR rims are the wrong PCD for the FL1, which uses the Honda 5 stud size.
- Posts
- 83,282
- Location
- Embasinga stocæ
i have it on good authority that Jeep ones fit 
.
.Some Jeep rims share the same PCD, but the spigot is completely wrong, leaving the wheels hung on the studs only, which is far from safe.i have it on good authority that Jeep ones fit
- Posts
- 83,282
- Location
- Embasinga stocæ
aaah!
