Shortandfluffy
New Member
- Posts
- 15
- Location
- Luton
Hi I have removed all bits to change front wheel bearings but can't seem to get back one Off any ideas ???
Wheel bearing removal
- Thread starter Shortandfluffy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
gozzy
Active Member
- Posts
- 418
- Location
- stratford upon avon
Pictures might help
John FHA
Active Member
- Posts
- 300
- Location
- Cleveleys, Blackpool
take an angle grinder to it but dont need to cut through. All you want to do is put heat on it. Be careful to only grind the baring. then give it a sharp tap with a hammer it will fall off. Or least come loose. 
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Large stilston. or similar or failing that a sharp chisel on the front edge. Belted by a larger hammer will uslally crack them, all the way thru. If not as said angle grinder 3/4 of the way thru and finished off with hammer & chisel. sorts em out.
blackhadder
New Member
- Posts
- 397
- Location
- Leicester
Tungsten carbide hacksaw blade is also useful, for when you can't use a grinder
RKServicing
Active Member
- Posts
- 757
- Location
- bicester
Grinder, chisel. And a big hammer. Better to hit it hard once than 30 times with a smaller one.
SteveD
Senile Member
- Posts
- 1,254
- Location
- Waltham Abbey
Always remember that spectacles are NOT safety goggles. But as the Doc at the hospital said "pieces of red hot metal are usually sterile"
Doh!
Attachments
gil
Active Member
- Posts
- 595
- Location
- Basingstoke
Been there my friend lol. Mine was stuck in for a week before I decide that I needed to seek medical attention. Got to the eye department and the specialist said it had gone rusty!! Had to have my eyeball polished lol.
I couldn't see anything stuck in my eye because I have dark brow eyes
SteveD
Senile Member
- Posts
- 1,254
- Location
- Waltham Abbey
That mark is just the burn but it felt like I had a housebrick stuck in there.
David Pye
Active Member
- Posts
- 623
- Location
- Newcastle Upon Tyne
Have to get it scraped off no doubt? I had a similar experience with a piece of chassis rust that fell in and stuck to my cornea.
Didn't notice why my eye was sore for 4 days..
Didn't notice why my eye was sore for 4 days..
