What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Lined the rear tub with 20mm ply and then with rubber flooring material
 

Attachments

  • IMAG0049.jpg
    IMAG0049.jpg
    163.9 KB · Views: 141
  • IMAG0050.jpg
    IMAG0050.jpg
    207.6 KB · Views: 171
Last edited:
Put some new Orange Silicone hose on the Turbo Boost pipe :cool: topped up the washer bottle reservoir, made a new connector for the starter motor trigger and gave him a good clean :D
Going to pick my new Yamaha TY250 tomorrow from Yorkshire :D 150miles, wish me luck :D
 
new indicator/dip switch arrived from the bay have to find some time to fit all these bits :confused:(also bought a steering colomn binical still not arrived yet ).
 
well had a few spare hrs this week so made my rock sliders
100x50 box shaped to go around pillers and under sills without hanging down , algled the 1.5" thick wall tube down by 15mm ( as thats the look i wanted )
just got to weld them on now then 3mm plate along the inside of sill , will also be plating from door rubbers down to slider
rocksliders005.jpg

rocksliders008.jpg

rocksliders011.jpg

rocksliders013.jpg

rocksliders012.jpg

rocksliders015.jpg


 
continued rubbing down and prepping for touch up paint, did the job, once again WRONG BLOODY COLOUR MATCH!!!for the third time grrrrr surely there must be somewhere that you can get the correct shade,,
 
couple of days ago put disco on ramps at front
and big wooden blocks at back to get underneath to check oil levels.
gearbox took a litre,
transfer box took litre & half !
ran out of oils so going to do it all again this week,
I hope.

bought in 2 litres of EP90
2 ltrs of EP140 (front swivels?)
1 ltr of power steering oil,
just in case...

mustgive the old girl an oil change before long too!....(the disco not the mrs)..
 
Last edited:
Back
Top