What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Fitted some tie-down points in the back of my Ninety so that I can strap my two ammo box toolkits down instead of having them sliding around in the back. It was too cold to do anything else!
 
finally got round to swapping the bucket seats back to originals, including a center seat at last. well, still in need of 2 bases but get them wednesday. anyone looking for some bucket seats? haha corbeau, will take 4 point harnesses and not too bad condition.
 
Picked up some Belts from Halfords for my Conversion, Done yet more work to it and had the exhaust delivered! (On a Sunday? :D)

Exhaust was not a straight fit as i have a Janspeed system, do a angle grinder was required... Need to weld it together tommorow :) With any luck i should have finished the whole job by tommorow? Only jobs left are Exhaust, fuel line, mounting the Rad and Intercooler and sorting the pipes out..
 
Spent last night pulling fair few peope up hills and out of ditches, including a fully laden 38T artic up a frozen hill.
Today got about 5 miles broken i lost near enough all power down to whqt i think is a dying lift pump. Idles, won't rev past 2k and under load struggles to 1500rpm then dies again.
Currently sat at the side of the road waiting for the RAC. :(
 
Spent last night pulling fair few peope up hills and out of ditches, including a fully laden 38T artic up a frozen hill.
Today got about 5 miles broken i lost near enough all power down to whqt i think is a dying lift pump. Idles, won't rev past 2k and under load struggles to 1500rpm then dies again.
Currently sat at the side of the road waiting for the RAC. :(
 
Co-Pang-Yang said:
Spent last night pulling fair few peope up hills and out of ditches, including a fully laden 38T artic up a frozen hill.
Today got about 5 miles broken i lost near enough all power down to whqt i think is a dying lift pump. Idles, won't rev past 2k and under load struggles to 1500rpm then dies again.
Currently sat at the side of the road waiting for the RAC. :(
Click to expand...
could be your diesel freezing
 
This is the funny thing. After about 15 minutes of idling its started reving fine. Drove a mile and started loosing power again, then after another miles lost almost all power again but luckerly was back at the workshop.
Trying to get the fuel filter off so we can hqve a look at the fuel.
Interestingly the Rac man said the company had heard the additives that Tesco had put in their diesel wasn't up to the job in these very cold conditions.
Guess where i filled up for the first time last night......
 
I'm fooking cold. MOT tomorrow replaced 2x uj's in th efooking snow, re wired my noo batteries fitted split charge awaiting wire to finish. Its fooking cold! built battery tray and clamp
 
did the last couple of odd bits on the old 90, then spent 15 minutes trying to start the bugger :mad:
then drove it over to the MOT guys ready for the morning, fingers crossed :D
 
You must log in or register to reply here.

Similar threads

B
defender 2.4 puma reverse light switch
Replies
4
Views
538
BEASTIE 90
B
Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
632
Padda.116
Padda.116
Knappster
Shot-blasting steel wheels
Replies
9
Views
914
Knappster
Knappster
Mooky
Replacing thermostat
Replies
14
Views
563
Mooky
Mooky
I
Re-coding of ABS Module after repacement
Replies
10
Views
990
invisible999
I
Back
Top