SHEDJIM
Well-Known Member
- Posts
- 1,480
- Location
- Wherever I lay my hat.
Put my engine back in. Just back from test drive all ok. yippee
What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Mark Disco
New Member
- Posts
- 1,094
- Location
- Bournemouth
spoke to Andyb666 yesterday, very genuine and helpfull guy, top bloke!!
fitted my new swivel ball today, it seems to have stopped the leaking but ive still got an ABS fault so will be sorting that tomorrow.
hopefully MOT next week!!
fitted my new swivel ball today, it seems to have stopped the leaking but ive still got an ABS fault so will be sorting that tomorrow.
hopefully MOT next week!!
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
got me new inverted dislocation cones off fleabay today , so had to go fit them didnt i
while i was up at me mates workshop doing them he said just going to go steam clean his landie , looked around the corner and saw this
bet his hi-lift jack goes higher than yers
while i was up at me mates workshop doing them he said just going to go steam clean his landie , looked around the corner and saw this
bet his hi-lift jack goes higher than yers
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
this coming from a former p38 driver
oi,less of the former mate,i have still got my p38.
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
oi,less of the former mate,i have still got my p38.
nuff said then
cant make yer fookin mind up then last thing i heard you was getting shot
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
nuff said then
cant make yer fookin mind up then last thing i heard you was getting shot
i'll do what i want mate,fook all to do with you.IS IT.
NessieB
New Member
- Posts
- 96
- Location
- NE Scotland
All I have done with mine today is watch it driving off taking my fella to work. Have to wait until 3:45pm to have it back.
dvb668w
Active Member
- Posts
- 257
- Location
- Gillingham Kent
renewed all the breaking system on the back of my SerIII
Test drive in the daylight later this week (fingers crossed)
Test drive in the daylight later this week (fingers crossed)
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
fitted an MP3 player in me series !
whats that cuz yer fed up with the constunt noise from that lump a **** under yer bonnet ?
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
fitted the new front +2" springs to the old 90
think i must have lost at least a stone in sweat the weekend apart fron the saggy front end
think i must have lost at least a stone in sweat the weekend apart fron the saggy front end
Phil_b
New Member
- Posts
- 273
- Location
- North shropshire
friday refitted wastegate, cleaned out cooler readjusted pipes,
today, checked my rad for hot/cold spots
today, checked my rad for hot/cold spots
Wriggler
New Member
- Posts
- 160
- Location
- Teesside / North Yorks
Started cutting away the rust on the rear cross member and cutting plates to fit
Muddy Gonzo
Banned
- Posts
- 2,509
- Location
- Chesterfield
Well a painful 18 hour gearbox change, taking the gearbox off 3 times switching the tranny box the find the cause of the problems we were having were down to a bent clutch fork.
Dont think pikey will be as quick to offer assistance to me again sometime soon.
But seriously a big thanks to Pikey and Topcat for all your help, I WONT FORGET IT.
Dont think pikey will be as quick to offer assistance to me again sometime soon.
But seriously a big thanks to Pikey and Topcat for all your help, I WONT FORGET IT.
Attachments
sniffmydiff
New Member
- Posts
- 170
- Location
- Bradford - West Yorkshire
Today iv'e Cut out the headlining at the front and started to make a custom overhead center console for CB, Roof Spots Switch, Landmeter, Turbo, Voltage And Clock Dials and interior light relocation
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Used it to escape from Chesterfield & driven to Hull.. & discovered why it's pulling left when I brake!! Fooking rear calliper is goosed & back wheel is covered in brake fluid
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
SHEDJIM
Well-Known Member
- Posts
- 1,480
- Location
- Wherever I lay my hat.
I would like to see some photos of that, so I can nick some ideasToday iv'e Cut out the headlining at the front and started to make a custom overhead center console for CB, Roof Spots Switch, Landmeter, Turbo, Voltage And Clock Dials and interior light relocation
sniffmydiff
New Member
- Posts
- 170
- Location
- Bradford - West Yorkshire
I would like to see some photos of that, so I can nick some ideas
I will post the pics when i get finished
Just hope it looks somewhat ok lol
