halo
Active Member
- Posts
- 660
- Location
- derbyshire
What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
gcb2309
Member
- Posts
- 27
- Location
- Byfleet surrey
changed the oil pressure switch and clutch cylinder oh and installed a radio in it as well the old girl needed a little bit of loving today
the wife does to but she is not as much fun off road
the wife does to but she is not as much fun off road
why?
you only just got it,get it durty first
Just so I could see what it was like underneath all the muck.
Co-Pang-Yang
Well-Known Member
- Posts
- 2,930
- Location
- Colchester, Essex
Took the front axle, suspension and brakes off my doner truck. Now just gotta decide if i just chuck it straight on mine and prey it'll go through the MOT this month or buy a cheap runaround and get new polybushes, paint it and get it all looking nice first.
hmmmm, decisions decisions.
hmmmm, decisions decisions.
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Took the front O/S wing off & removed the fooked aerial. & replaced it with one I pikied off Ratty. Then took it to the jet wash and gave it a clean.
- Posts
- 14,902
- Location
- Doncaster
Heheh, must be a day for it ....
Changed oil and filters, Jet-Washed it .. then removed diff guard (bolt-on jobbies) to clean the crud and check them .. the drain holes are always clogged up!
Added some sealer to all the snorkel joints, I'd run it for a while without to let it all settle, and it now sounds a lot quieter ..
Then just bits and pieces tidied up. Keep meaning to remove the egr plumbing actual manifold valve went ages ago) but need a straight connector for where the tubes branch off the main vacuum pipe, so keep leaving it 'cos I keep forgetting a straight connector! At the mo' it has golf tees jammed into the pipe ends!!
Changed oil and filters, Jet-Washed it .. then removed diff guard (bolt-on jobbies) to clean the crud and check them .. the drain holes are always clogged up!
Added some sealer to all the snorkel joints, I'd run it for a while without to let it all settle, and it now sounds a lot quieter ..
Then just bits and pieces tidied up. Keep meaning to remove the egr plumbing actual manifold valve went ages ago) but need a straight connector for where the tubes branch off the main vacuum pipe, so keep leaving it 'cos I keep forgetting a straight connector! At the mo' it has golf tees jammed into the pipe ends!!
Andy200TDi
New Member
- Posts
- 269
- Location
- Nottinghamshire
Fixed door lock so that it opens without extra tweak from the key! Changed driver side lower link bush! Will do the other side next week.
little tip here... the new bush is thicker than the old and that means that the rear link arm bolt holes don't line up... use a ratchet strap around the axle and hook up to the rear chasis to pull the axle back and line the holes up so the bolt goes in.
little tip here... the new bush is thicker than the old and that means that the rear link arm bolt holes don't line up... use a ratchet strap around the axle and hook up to the rear chasis to pull the axle back and line the holes up so the bolt goes in.
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
popped up the road in the td5 to pick up a car for a mates rug rat with his car transporter
was well pleased with how she ran 320 miles round trip = 57 litres
had a slight detour to upset 1 of dafts neighbours by driving on "his" grass :doh:
was well pleased with how she ran 320 miles round trip = 57 litres
had a slight detour to upset 1 of dafts neighbours by driving on "his" grass :doh:
- Posts
- 83,282
- Location
- Embasinga stocæ
He came up and apologised later for being a "grumpy old bugger" - i said it was ok - coz yu was anorl
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
That works out about 25mpg. Not bad considering ya had a car on the back.
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
yeah the trailer towed like a bitch empty and we took a few back roads on the way back to miss the M25
Mr Fleg
New Member
- Posts
- 69
- Location
- middlesbrough
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
He came up and apologised later for being a "grumpy old bugger" - i said it was ok - coz yu was anorl
bet ya did'nt tell him what i was tempted to do did ya?
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
- Posts
- 83,282
- Location
- Embasinga stocæ
nope
![[JP]](/data/avatars/m/29/29578.jpg?1437394565){kind=avatar}
[JP]
New Member
- Posts
- 3,980
- Location
- Newbury, Berks
I finally fitted the snorkel on the 90....
Garth of the west
New Member
- Posts
- 36
Fixed my central locking! Kerchow!
