What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Just decided how much better my 200tdi is compared to a TD5. My dad had a TD5 discovery to fix that kept stalling and not re-starting. RAC fella told my dads mate that it was the tank fuel pump. £270 of genuine pump later, still the same, and no fault codes showing up. Wouldn't trust a TD5 as far as I could throw it.
My dad and I are going to a motorbike show this weekend, 200miles round trip, I can rely on my 200tdi getting us there, but wouldn't trust a TD5 after that.


That's electronics for ya. Good old fashioned diesel any day.
 
changed oil in front & rear diffs, I changed filler plug to a nice brass one at the same time as well.

Changed oil filters and changed engine oil.
Ran out of time, so will be doing gear & transfer box soon as well.
 
Prepped my roof bar and spotlights ready for Tuesday, when she goes to the auto electricians! Emptied a carrier bag of mud from under the tow bar, and treated it to a lick of paint! Looks much better! :tea:
Also re-positioned my external temperature sensor so hopefully it'll be more accurate!
 
Had my first go at doing the wheel bearings:)
Managed to get the front ones done, have to leave the rears for next weekend.

Not too bad of a job once I managed to figure out how to get the calipers off along with the brake pipe bracket. Everything was hidden under 2 inches of mud.
 
Morning all. Drove mine after fitting a new clutch Friday and sat :).

Had a bit of trouble starting it this mornin. Though, the starter relay clicked when I turned the key to 3rd position. But the starter motor didn't turn over or anything like that. Was thinking one of the switches in the relay has worn? Took me a while to get it then over, turned it on and off until it went.

Also noticed that where I hadn't taken the negative off the battery, as we pulled the gear box away it was sparking on the chassis (don't think any wires were attached to the box at this point). Don't know if the two problems are linked at all but anyone have any idea what it could be? Cheers
 
Check the earths ;)

When you moved gearbox did you take off the chassis earth?? on the chassis front crossmember bolt.
With a bad earth it will struggle to start or not at all.
I made this mistake when I took my gearbox out I forgot to put the earth back on the chassis. It started once but struggled then switched it off and tried to start again and nothing.. Soon realised the earth wasn't attched
 
Last edited:
Ooo ok I shall have a look at that! I didn't take the mount of. Someone who works next door to me who was a mechanic did it. I wouldn't be confident enough to do allll that! ;) but I shall have a look for any dangling wires :) is it on near side or far side of gearbox?
 
Far side (passengers), will be on one if the two top bolts that go through the crossmember into the chassis if I remember!! Is the same size cable as used on the battery. Would go out take a pic but it's rather wet ;)
 
Last edited:
Tried by passing it with a jump lead to engine bay. Get the starter click and relay but won't turn over. Though motor may be stuck so gave it a tap. Nothing, did notice sparks coming off it though when I tapped it with something metal. Bit odd
 
9y4ydysa.jpg


Finished pulling bits off mine now. Paint needs a bloody good flat back and the rest of the dings want filled in, then its paint time. MOT is in a week......
 
cleaned the spray paint off my windows that some scumbag #### decided to spray all over my windows last night at some point
 
Back
Top