- Posts
- 10,639
- Location
- Oxfordshire
What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Chrisw8
Well-Known Member
- Posts
- 1,980
- Location
- Top of the Hill
done some prep work for refitting swivel housing etc
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
made it run 
, found one last leak and wired up the fuel sender
, found one last leak and wired up the fuel sender 
Lazy Landy
New Member
- Posts
- 1,372
- Location
- Durham
I have seam sealed round the welds on the footwell I've welded in and cleaned years of underseal, oil and crud off my steering box column ready for the new top bearing, hopefully arriving tomorrow.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 62,869
- Location
- Gloucestercotshirewolds
New track rod end fitted, took a little play out the front near-side wheel bearing and swivel pin. One shackle bush to do and she's ready for the mot.
Made a plan for picking up the ambulance...
Made a plan for picking up the ambulance...
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
blue beasty
Leaks an prone to bits dropping off
- Posts
- 62,869
- Location
- Gloucestercotshirewolds
Does that involve taking the train to pick it up then calling the RAC
Involves taking some hub seals, a full compliment of fluids and filters and a pre-booked mot
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
oooh its a good one then
I'm off to mess with the V8's wiring and timing, need to order a new barrel too…….pulled a muscle in my back so probably wont be fitting the exhaust til tomorrow
I'm off to mess with the V8's wiring and timing, need to order a new barrel too…….pulled a muscle in my back so probably wont be fitting the exhaust til tomorrow
- Posts
- 14,902
- Location
- Doncaster
Loaned it to the missus ...
Took her Mondeo for an MOT, failed on a lower front suspension ball joint .. so that's the 'tapping' she said she could hear then!!
Ah well, new one bought and car stripped as far as I can till me decent tools return in the back of the Disco!!
Took her Mondeo for an MOT, failed on a lower front suspension ball joint .. so that's the 'tapping' she said she could hear then!!
Ah well, new one bought and car stripped as far as I can till me decent tools return in the back of the Disco!!
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
About to go mess with the timing…..again
the_wolf
Well-Known Member
- Posts
- 16,791
- Location
- Stonehouse, Scotland
Used it to take some stuff to the tip and marvelled at how much warmer it is with a truck cab on
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
Fecking typical just sorted out the battery cable with a nice new lug and it starts raining…...
just sorted out the battery cable with a nice new lug and it starts raining…...
concal
New Member
- Posts
- 157
- Location
- chesterfield
Not today but yesterday started work at 6 finished at 3 then disco straight in garage at work and replaced swivel seal and replaced bearings finished at 11 last night (fecked isn't the word)
Only the other side to do now!!!!
Bastid of a job anorl
Only the other side to do now!!!!
Bastid of a job anorl
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
Fitted the exhaust, sorted the idle (more or less) and sorted a bit of the wiring
Lazy Landy
New Member
- Posts
- 1,372
- Location
- Durham
Sprayed some primer on my new footwell, starting to get some ware if I get a little bit done every night. Half an hour workshop tidying now.
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Should have just fitted white leds they turn the dash blue with the green filters intact.
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Discovered why me brakes have gone to ****e. SErvo Vacuum Pump is spewing Oil everywhere. But I've sourced a replacement so hopefully all will be sorted tomorrow.
Markieboi
Member
- Posts
- 63
- Location
- County Durham
Primed up my new wheels ready for paint tomorrow afternoon.
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
Finally sorted the engine!
