- Posts
- 68,202
- Location
- The Wooly Witch
Changed the air filter and fuel filter today
Gonna have to do the intercooler soon ...
Gonna have to do the intercooler soon ...
What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
timtheenchanteruk
Well-Known Member
- Posts
- 4,633
- Location
- Leeds
Yep, n they don't give any notice, with landys it's fine... Fine..... Fine.... Cough splutter, dead
RealSillyTilly
New Member
- Posts
- 30
On my way outside to put the Landy back together
Wish me luck
Good luck, I'm putting mine back together tomorrow, and Sunday and Monday...
Big Mat
Well-Known Member
- Posts
- 943
- Location
- King's Lynn, Norfolk
Changed the rear door lock as the old one was very tempermental and i didnt want to leave it unlocked in the marsh car park.
Will give it a clean and check all fluid levels tomorrow.
Will give it a clean and check all fluid levels tomorrow.
defender11069
AKA Mr cool...
- Posts
- 8,616
- Location
- up sh*t creek with out a paddle
went night laning in it with a load of LZ looney tunes wos a very good night
sarah90
Well-Known Member
- Posts
- 1,766
- Location
- West Yorkshire
Ttuck3r
Active Member
- Posts
- 204
- Location
- Perthshire Scotland
Fitted new windscreen an new seal, some job for a first timer on his own!
myfirstl322
Well-Known Member
- Posts
- 41,354
- Location
- Hoots mon...
N/s rocker gasket on my 4.4 L322, did O/s, bit of a bitch, but N/s has more stuff in the way, ie, Lpg vapouriser, some sort of coolant valve and stuff
Grazed knuckles and a boot in the balls for the dog i foresee NOT my dog, heavens above. Its my M8's.:cool2:
Grazed knuckles and a boot in the balls for the dog i foresee
NOT my dog, heavens above. Its my M8's.:cool2:
Last edited:
How bad of a job was it, I'm thinking of attempting this soon
Ttuck3r
Active Member
- Posts
- 204
- Location
- Perthshire Scotland
It would be an easy job if you can get help to apply some pressure from the outside whilst pulling in the cord on the inside, and get some soapy liquid around to help the process.
Wonder if a rubber with an insert (like Minis etc) would do the job, might not be as tight a fit until the strip goes in and that's easy with a tool
Kev@kenninghall
Well-Known Member
- Posts
- 902
- Location
- Norfolk
New front dampers and galvanised heavy duty turrets. What a sod getting the old one out!
Had to take the angle grinder to the old turret and take it out in pieces.
Had to take the angle grinder to the old turret and take it out in pieces.
OxonLandy
Active Member
- Posts
- 574
- Location
- nr Abingdon, Oxon
SteveD
Senile Member
- Posts
- 1,254
- Location
- Waltham Abbey
Ordered a bumper and hockey panels. Just need to take a hammer to the bonnet and we are good to go
scottant
New Member
- Posts
- 107
- Location
- East Donyland, Nr Colchester, Essex
Fitted 2 rear shocks (yesturday i admit but close enough) and started sorting out my new light bar got to wire it up tomorrow and it'll be good to go. Oh and ive got to check the range rover over before peterborough.
got to wire it up tomorrow and it'll be good to go. Oh and ive got to check the range rover over before peterborough.
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
ordered a 175 amp alternator off the bay, should negate the need for twin batteries and split chargers
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
course it does how often do you use a winch I aint doing winch challenges.
have been with more than 1 landy with twin batteries that couldn't keep up with their winch , that baby wont take bugger all out of the battery.
lad that gave me the link on the bay uses one on his 8274 without 2 batteries
have been with more than 1 landy with twin batteries that couldn't keep up with their winch , that baby wont take bugger all out of the battery.
lad that gave me the link on the bay uses one on his 8274 without 2 batteries
