What have you done to your Freelander today

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Dawen35 said:
I took the bottom of the injector off, took pin out etc and cleaned in an ultrasonic bath full of degizer for 30 mins. One of the injectors was totally blocked which is the one I started with as, if it broke, nothing lost. All went well so I did the other one that wasn't affecting the running as bad but when disconnected there wasn't a major difference.

The job, initially, was quite scary but with a little care on how it came apart and ensuring that you don't drop the little parts it wasn't too bad. I will probably do the other two when I get time and will take pictures if interested.

Dai
Click to expand...


Hi Dai.
Thank you and am always interested in good educational posts as we are always learning, even better if backed up with photo's I think, I try and photo all the work I carry out on my cars for future reference and to help on the forums if I can, cheers Arctic2
 
Took off props and VCU to test if the noise i am getting comes from the VCU bearings

Wrong .......... so had to put it back on again

My noise sounds like front wheel bearings - i've seen these at all sorts of prices including an offer from Poland with the bearing pre-fitted to the hub

Where is the "best" (cheapest for a good quality bearing) to go ???
 
not today but over the weekend...
replaced this:

and fitted these:

so I could install these:

and gave the rear diff an oil change and a lick of paint:

now I need new:
dif mounts; ARB bushes and drop links; VCU bearings and UJs
 
Last edited:
Replaced LH g'box side seal, fitted same drive shaft with it's new CV boots, refilled the g'box with oil. Waiting on DHL to deliver parts from UK - Fuel pump arrived yesterday - sent off from same supplier at the same time :(
 
digby said:
Took off props and VCU to test if the noise i am getting comes from the VCU bearings

Wrong .......... so had to put it back on again

My noise sounds like front wheel bearings - i've seen these at all sorts of prices including an offer from Poland with the bearing pre-fitted to the hub

Where is the "best" (cheapest for a good quality bearing) to go ???
Click to expand...

I just purchased from LR Direct. Famous Four do a good price too. Check that if you buy the bearing does it come with the nut and cir clip. The kit does but if you buy the bearing separate then you need to get the other bits too.
 
Fitted new Fuel pump this evening. Pressed in new front wheel bearing ready to refit drive shaft in the morning. Drive flange is in the freezer to make pressing this onto the steering knuckle/hub mount easier!
 
Thanks HTR

what size press do you need to get the front wheel bearings in ??

will a big bench vice do the trick ??
 
Changed three abs sensors but the dam three amigos still on. I've replaced the brake switch to a newer on but still on. ####en thing is driving me to poverty lol
 
You must log in or register to reply here.

Similar threads

T
Help!
Replies
13
Views
657
Nodge68
Nodge68
B
Freelander TD4 Mk1 Rear Diff - Does anyone have any advice on how to replace the rear diff?
Replies
1
Views
249
Freddie17
Freddie17
R
LED side lights not working
Replies
9
Views
725
RickyFreelander
R
C
Rear wheel bearings or diff
Replies
11
Views
1K
Nodge68
Nodge68
L
Freelander 1 2005 Land Rover Freelander 1 HSE - Loose Gear Selector in Automatic Transmission
Replies
3
Views
628
Hippo
Hippo
Back
Top