What have you done on your 90/110/130 today?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Tried to remove the steering wheel to clear the way for swapping out the indicator switch that is on order - seized on the splines solid, no amount of large hammer, PlusGas and swearing will shift it.

Have bought a dedicated puller tool to see if it will surrender later in the week….every little thing fights me all the way.

Now very close to throwing all the spares from the garage in the back of this thing and dumping it


Grrrrrrr
 
slomofo said:
Tried to remove the steering wheel to clear the way for swapping out the indicator switch that is on order - seized on the splines solid, no amount of large hammer, PlusGas and swearing will shift it.

Have bought a dedicated puller tool to see if it will surrender later in the week….every little thing fights me all the way.

Now very close to throwing all the spares from the garage in the back of this thing and dumping it


Grrrrrrr
Click to expand...
It never ceases to amaze me the Defender :rolleyes:. Just how can such a vehicle be so sought after and highly priced when there's so many things that go wrong with them. I remember replacing the indicator stalk on a few of my previous trucks...joy.

My 15 year old 170k miles F2 indicator stalk will probably last as long as the car itself.....strange don't you think? :D
 
slomofo said:
Tried to remove the steering wheel to clear the way for swapping out the indicator switch that is on order - seized on the splines solid, no amount of large hammer, PlusGas and swearing will shift it.

Have bought a dedicated puller tool to see if it will surrender later in the week….every little thing fights me all the way.

Now very close to throwing all the spares from the garage in the back of this thing and dumping it


Grrrrrrr
Click to expand...
Always leave the nut in a few threads as if the wheel comes off it attacks you like a rabid frisbee

have you tried the knee pushing behind the wheel & soft mallet to the nut… steering wheel nut… unless you miss
 
potus said:
It never ceases to amaze me the Defender :rolleyes:. Just how can such a vehicle be so sought after and highly priced when there's so many things that go wrong with them.
Click to expand...

Because owners treat them like **** and fail to maintain them properly + most have no idea just what high maintenance buses LR's are. Then they wonder why everything's rusty and/or covered in **** with every component seized...o_O
 
slomofo said:
Tried to remove the steering wheel to clear the way for swapping out the indicator switch that is on order - seized on the splines solid, no amount of large hammer, PlusGas and swearing will shift it.

Have bought a dedicated puller tool to see if it will surrender later in the week….every little thing fights me all the way.

Now very close to throwing all the spares from the garage in the back of this thing and dumping it


Grrrrrrr
Click to expand...

You should not need a large hammer. What type of steering wheel puller are you using? With plusgas, a little heat and a proper flat plate puller left under tension the wheel should pull straight off...it's only a simple spline ;)
 
v8250 said:
You should not need a large hammer. What type of steering wheel puller are you using? With plusgas, a little heat and a proper flat plate puller left under tension the wheel should pull straight off...it's only a simple spline ;)
Click to expand...
That is rusted on……

Going to use one of these jobbies;
66093A13-60D5-46ED-9CCD-5801DC9349C4.jpeg
 
One of those worked on my four spoke which hadn't been taken off in years and was very seized.
Lots of release spray beforehand and tighten the bolts on each side slowly and evenly until seated flush then slowly tighten the big bolt. Mine groaned as I tightened it and looked like it might bend the bar but then it suddenly released.
I cleaned the threads and smeared some grease on before replacing the wheel; the securing nut should be tight, doesn't have to be hernia tight.
 
potus said:
It never ceases to amaze me the Defender :rolleyes:. Just how can such a vehicle be so sought after and highly priced when there's so many things that go wrong with them. I remember replacing the indicator stalk on a few of my previous trucks...joy.

My 15 year old 170k miles F2 indicator stalk will probably last as long as the car itself.....strange don't you think? :D
Click to expand...

Unlike other things where you can suggest it's a love or hate relationship , owning a landy is a love AND hate relationship
 
v8250 said:
Because owners treat them like **** and fail to maintain them properly + most have no idea just what high maintenance buses LR's are. Then they wonder why everything's rusty and/or covered in **** with every component seized...o_O
Click to expand...
The doris rolls her eyes a bit every time I say I'm just going to do "whatever" to either the 90 or Buttercup, but there again when was the last time we broke down? can't remember the exact date but it was sometime in the 90's when my Volvo managed to rip the prop shaft in two when pulling out of a junction.
 
You must log in or register to reply here.

Similar threads

DefendingLancashire
300TDI Four-parter: brake wear, lift pump / fuel filter, turbo, and bushes / squeaking
Replies
13
Views
661
miktdish
miktdish
F
What have you done with your series today?
Replies
4
Views
1K
Frustrated Seriesist
F
Blob
L322 Let's have your technical opinions then. Coolant leak and cracked manifold?
2
Replies
24
Views
4K
Blob
Blob
Hippo
What have you done to your tratter today?
2 3 4
Replies
70
Views
7K
IamRobbie
IamRobbie
Hippo
What have you done to your tratter today?
2
Replies
35
Views
4K
dominicbeesley
dominicbeesley
Back
Top